YMF740C Datasheet, PDF (13/44 Pages) List of Unclassifed Manufacturers – DS-1L

YMF740C
2C-2Dh: Subsystem Vendor ID
Read Only
Default: 1073h
Access Bus Width: 8, 16, 32-bit
b15 b14 b13 b12 b11 b10 b9 b8 b7 b6 b5 b4 b3 b2 b1 b0
Subsystem Vendor ID
b[15:0] ........Subsystem Vendor ID
This register contains the Subsystem Vendor ID. In general, this ID is used to distinguish adapters or
systems made by different IHVs using the same chip by the same vendor. This register is read only. To
write the IHV’s Vendor ID, use 44-45h (Subsystem Vendor ID Write Register).
The default value is the YAMAHA's Vendor ID, 1073h. IHVs must change this ID to their Vendor ID in
the BIOS POST routine.
2E-2Fh: Subsystem ID
Read Only
Default: 000Ch
Access Bus Width: 8, 16, 32-bit
b15 b14 b13 b12 b11 b10 b9 b8 b7 b6 b5 b4 b3 b2 b1 b0
Subsystem ID
b[15:0] ........Subsystem ID
This register contains the Subsystem ID. In general, this ID is used to distinguish adapters or systems
made by different IHVs using the same chip by the same vendor. This register is read only. To write
the IHV's Device ID, use 46-47h (Subsystem ID Write Register).
The default value is the YAMAHA's Device ID, 000Ch. IHVs must change this ID to their ID in the
BIOS POST routine.
34h: Capability Register Pointer
Read Only
Default: 50h
Access Bus Width: 8, 16, 32-bit
b7 b6 b5 b4 b3 b2 b1 b0
Capability Register Pointer
b[7:0] ..........Capability Register Pointer
This register indicates the offset address of the Capabilities register in the PCI Configuration register
when 58-59h: ACPI Mode register, ACPI bit is “0”. DS-1L provides PCI Bus Power Management
registers as the capabilities. The Power Management registers are mapped to 50h - 57h in the PCI
Configuration register, and this register indicates “50h”.
When ACPI bit is “1”, this register indicates “00h”.
January 14, 1999
-13-