SGU04G64A1BE1MT-BBR Datasheet, PDF (1/16 Pages) List of Unclassifed Manufacturers – 4096MB DDR3 – SDRAM UDIMM

preliminary Data Sheet
Rev.0.9 22.07.2013
4096MB DDR3 – SDRAM UDIMM
240 Pin UDIMM
SGU04G64A1BE1MT-xxR
4GByte in FBGA Technology
RoHS compliant
Options:
 Data Rate / Latency
DDR3 1066 MT/s CL7
DDR3 1333 MT/s CL9
DDR3 1600 MT/s CL11
 Module Density
4GByte with 8 dies and 1 rank
Marking
-BB
-CC
-DC
Features:
 240-pin 64-bit DDR3 unbuffered Dual-In-Line Double Data
Rate Synchronous DRAM module
 Module organization: single rank 512M x 64
 VDD = 1.5V ±0.075V, VDDQ 1.5V ±0.075V
 1.5V I/O ( SSTL_15 compatible)
 Fly-by-bus with termination for C/A & CLK bus
 Serial presence-detect (SPD) EEPROM
 Gold-contact pads
 This module is fully pin and functional compatible to the
JEDEC PC3-12800 spec. and JEDEC- Standard MO-268.
(see www.jedec.org)
 The pcb and all components are manufactured according
to the RoHS compliance specification [EU Directive
2002/95/EC Restriction of Hazardous Substances (RoHS)]
Standard Grade
(T_A)
0°C to 70°C ^
(T_C)
0°C to 85°C



*) The refresh rate has to be doubled when 85°C<TC<95°C 
Environmental Requirements:

 Operating temperature (ambient)

Standard Grade
 Operating Humidity
0°C to 70°C

10% to 90% relative humidity, noncondensing
 Operating Pressure
105 to 69 kPa (up to 10000 ft.)
 Storage Temperature
-55°C to 100°C
 Storage Humidity
5% to 95% relative humidity, noncondensing
 Storage Pressure
1682 PSI (up to 5000 ft.) at 50°C
DDR3 - SDRAM component Micron
MT41K512M8RH-125:E
512Mx8 DDR3 SDRAM in PG-TFBGA-78 package
8-bit prefetch architecture
Programmable CAS Latency, CAS Write Latency, Additive
Latency, Burst Length and Burst Type.
On-Die-Termination (ODT) and Dynamic ODT for improved
signal integrity.
Refresh. Self Refresh and Power Down Modes.
ZQ Calibration for output driver and ODT.
System Level Timing Calibration Support via Write Leveling
and Multi Purpose Register (MPR) Read Pattern.
Figure: mechanical dimensions¹
Swissbit AG
Industriestrasse 4
CH-9552 Bronschhofen
Fon: [phone]
Fax: [phone]
1_{if no tolerances specified ± 0.15mm}
www.swissbit.com
eMail: [e-mail]
Page 1
of 16