E-1071 Datasheet, PDF (5/6 Pages) ETAL Group – Designed for inductive loads (DC 24 V)

Solid State Remote Power Controller E-1071-623/627
Application note:
Controlling and monitoring of solenoid valves in combination with LED valve plugs
Possible configuration of E-1071-62x
with screw terminals:
with screwless terminals:
E-1071-623-DC 24 V-0.1...3.1 A
E-1071-627-DC 24 V-0.1...3.1 A
Please note:
l In the event of using a plug or suppressor element not
recommended, the wire break monitoring function might be
limited in the not activated condition.
Often DC 24 V solenoids with a low power rating are used which are
to be controlled and monitored by the above mentioned devices.
Sometimes these solenoids are fitted with solenoid valve plugs, e.g.
made by Hirschmann, and hold a small electronic pcb
- with LED,
- a series resistor
- a protective diode connected in anti-parallel to the LED
The following components can be recommended:
l Recommended valve plugs with LED, Hirschmann
- type GDML 2011 LED 24 YE, contains the pcb
type GDME-LED 24 YE
- type GDML 2011 LED 24 RD, contains the pcb
type GDME-LED 24 RD
status indication (LED) with a protective diode connected in
anti-parallel
(+)
(+) 1
∼
∼
(-)
(-) 2
∼
∼
l Recommended adapter with LED, Murr Elektronik
5
- suppressor element model B – 10 mm LED,
24 V DC/50 VA/W, part no.: 3124875
- suppressor element model BI – 11 mm LED,
24 V AC/DC/50 VA/W, part no.: 3124215
- suppressor element model C – 8 mm LED,
24 V AC/DC/50 VA/W, part no.: 312811
1646
All dimensions without tolerances are for reference only. In the interest of improved design,
performance and cost effectiveness the right to make changes in these specifications wit-
hout notice is reserved.Product markings may not be exactly as the ordering codes. Errors
and omissions excepted.
www.e-t-a.de
5