EN25S32 Datasheet, PDF (59/59 Pages) Eon Silicon Solution Inc. – 32 Megabit 1.8V Serial Flash Memory with 4Kbyte Uniform Sector

Revisions List
EN25S32
Revision No Description
Date
A
Initial Release
2010/06/24
B
Revise the description of Reset Quad I/O (FFh) command on page 16. 2010/07/19
1. Rename 38h command from Enable Quad I/O (EQIO) to Enable
Quad Peripheral Interface mode (EQPI).
C
2. Revise the description of RSTQIO (FFh) and add the function of
Release Quad I/O Fast Read Enhancement Mode.
2011/01/03
3. Add Read Burst (0Dh) command on page 13 and 34.
4. Update Table 15. AC Characteristics on page 52.
D
Add package option of 8-pin 200mil VSOP
2011/02/08
1. Add 32KB Block and related descriptions.
E
2. Revise t_SHSL (CS# High Time for read) from 10ns to 30ns and update _2011/02/21
t_CLQV from 9ns to 8ns on page 52.
F
1. Correct the typo of 6 dummy clocks on page 28.
2. Update Figure 24. Write Suspend/Resume Flow on page 39.
2011/05/26
1. Add the note “5. This flow cannot release the device from Deep power
G
down mode.” on page 16.
2011/06/28
2. Update Table 15. AC Characteristics on page 52.
H
Remove the 8-pin 200mil SOP package option.
2011/07/06
I
Supplement the description of suspend and resume latency timing on
page 36, 37, 38 and 39.
2011/12/15
1. Remove 32KB blocks and relative description.
J
2. Remove Fast Read Burst with wrap (0Dh) command and relative 2012/01/19
description.
This Data Sheet may be revised by subsequent versions
59
or modifications due to changes in technical specifications.
©2004 Eon Silicon Solution, Inc.,
Rev. J, Issue Date: 2012/01/19
www.eonssi.com