EN25S32 Datasheet, PDF (32/59 Pages) Eon Silicon Solution Inc. – 32 Megabit 1.8V Serial Flash Memory with 4Kbyte Uniform Sector

EN25S32
Set Burst (C0h)
The Set Burst command specifies the number of bytes to be output during a Read Bust command
before the device wraps around. To set the burst length the host driver CS# low, sends the Set Burst
command cycle (C0h) and one data cycle, then drivers CS# high. A cycle is two nibbles, or two clocks,
long, most significant nibble first. After power-up or reset, the burst length is set to 8 bytes (00h), please
refer to Table 9 for burst length data and Figure 18 for the sequence.
Table 9. Burst Length Data
Burst length
8 Bytes ( default)
16 Bytes
32 Bytes
64 Bytes
128 Bytes
256 Bytes
High Nibble (H0)
0h
0h
0h
0h
0h
0h
Low Nibble (L0)
0h
1h
2h
3h
4h
5h
Figure 18 Set Burst Instruction Sequence Diagram
This Data Sheet may be revised by subsequent versions
32
or modifications due to changes in technical specifications.
©2004 Eon Silicon Solution, Inc.,
Rev. J, Issue Date: 2012/01/19
www.eonssi.com