EN25Q80B Datasheet, PDF (50/64 Pages) Eon Silicon Solution Inc. – 8 Megabit Serial Flash Memory with 4Kbyte Uniform Sector

Read Unique ID Number
EN25Q80B
The Read Unique ID Number instruction accesses a factory-set read-only 96-bit number that is unique
to each EN25Q80B device. The ID number can be used in conjunction with user software methods to
help prevent copying or cloning of a system. The Read Unique ID instruction is initiated by driving the
CS# pin low and shifting the instruction code “5Ah” followed by a three bytes of addresses, 0x80h, and
one byte of dummy clocks. After which, the 96-bit ID is shifted out on the falling edge of CLK as shown
in Figure 29.
Table 10. Unique ID Number
Description
Unique ID Number
Address (h)
(Byte Mode)
80h : 8Bh
Address
(Bit)
95 : 00
Data
By die
Comment
Power-up Timing
Figure 30. Power-up Timing
Table 11. Power-Up Timing and Write Inhibit Threshold
Symbol
Parameter
tVSL
VCC(min) to CS# low
tPUW _{Time delay to Write instruction}
VWI
Write Inhibit Voltage
Note:
1.The parameters are characterized only.
2. VCC (max.) is 3.6V and VCC (min.) is 2.7V
Min.
10
1
1
Max. Unit
µs
10
ms
2.2
V
INITIAL DELIVERY STATE
The device is delivered with the memory array erased: all bits are set to 1 (each byte contains FFh).
The Status Register contains 00h (all Status Register bits are 0).
This Data Sheet may be revised by subsequent versions
50
or modifications due to changes in technical specifications.
©2013 Eon Silicon Solution, Inc.,
Rev. B, Issue Date: 2013/10/16
www.eonssi.com