English
Language : 

EN29GL128H_10 Datasheet, PDF (49/54 Pages) Eon Silicon Solution Inc. – 128 Megabit (16384K x 8-bit / 8192K x 16-bit) Flash Memory Page mode Flash Memory, CMOS 3.0 Volt-only
ABSOLUTE MAXIMUM RATINGS
Parameter
Storage Temperature
Plastic Packages
Ambient Temperature
With Power Applied
Output Short Circuit CurrentP1P
Voltage with
Respect to Ground
OE#, RESET# P Pand
WP#/ACCP2P
All
other
pins
3
P
P
EN29GL128H/L
Value
Unit
-65 to +150
°C
-65 to +125
°C
-55 to +125
°C
200
mA
-0.5 to + 9.5
V
-0.5 to Vcc+0.5
V
Vcc
-0.5 to + 4.0
V
Notes:
1. No more than one output shorted at a time. Duration of the short circuit should not be greater than one second.
2. Minimum DC input voltage on OE#, RESET# and WP#/ACC pins is –0.5V. During voltage transitions, OE#, RESET# and
WP#/ACC
pins
may
undershoot
V ss B
B
to
–1.0V
for
periods
of
up
to
50ns
and
to
–2.0V
for
periods
of
up
to
20ns.
See figure below.
Maximum DC input voltage on OE#, and RESET# is 8.5V which may overshoot to 9.5V for periods up to 20ns.
3.
Minimum DC voltage on input or I/O pins is –0.5 V.
During
voltage
transitions,
inputs
may
undershoot
V ss B
B
to
–1.0V
for
periods
of
up to 50ns and to –2.0 V for periods of up to 20ns.
See figure below.
Maximum
DC
voltage
on
output
and
I/O
pins
is
V cc B
B
+
0.5
V.
During
voltage
transitions,
outputs
may
overshoot
to
V cc B
B
+
1.5
V
for
periods
up
to
20ns.
See figure below.
4. Stresses above the values so mentioned above may cause permanent damage to the device. These values are for a stress
rating only and do not imply that the device should be operated at conditions up to or above these values. Exposure of the
device to the maximum rating values for extended periods of time may adversely affect the device reliability.
RECOMMENDED OPERATING RANGES1
P
P
Parameter
Value
Unit
Ambient Operating Temperature
Industrial Devices
-40 to 85
°C
Operating Supply Voltage
Vcc
Full Voltage Range:
2.7 to 3.6V
V
1.
Recommended Operating Ranges define those limits between which the functionality of the device is guaranteed.
Vcc
+1.5V
Maximum Negative Overshoot
Waveform
Maximum Positive Overshoot
Waveform
This Data Sheet may be revised by subsequent versions
49
or modifications due to changes in technical specifications.
©2004 Eon Silicon Solution, Inc.,
Rev. K, Issue Date: 2010/05/11
www.eonssi.com