EN25QH32 Datasheet, PDF (39/63 Pages) Eon Silicon Solution Inc. – 32 Megabit Serial Flash Memory with 4Kbyte Uniform Sector

EN25QH32
Figure 22. Release Power-down Instruction Sequence Diagram
Figure 23. Release Power-down / Device ID Instruction Sequence Diagram
Read Manufacturer / Device ID (90h)
The Read Manufacturer/Device ID instruction is an alternative to the Release from Power-down /
Device ID instruction that provides both the JEDEC assigned manufacturer ID and the specific device
ID.
The Read Manufacturer/Device ID instruction is very similar to the Release from Power-down / Device
ID instruction. The instruction is initiated by driving the CS# pin low and shifting the instruction code
“90h” followed by a 24-bit address of 000000h. After which, the Manufacturer ID for Eon (1Ch) and the
Device ID are shifted out on the falling edge of CLK with most significant bit (MSB) first as shown in
Figure 24. The Device ID values for the EN25QH32 are listed in Table 5. If the 24-bit address is initially
set to 000001h the Device ID will be read first
The instruction sequence is shown in Figure 24.1 while using the Enable Quad Peripheral Interface mode
(EQPI) (38h) command.
This Data Sheet may be revised by subsequent versions
39
or modifications due to changes in technical specifications.
©2004 Eon Silicon Solution, Inc.,
Rev. E, Issue Date: 2012/01/30
www.eonssi.com