EN25Q16 Datasheet, PDF (30/40 Pages) Eon Silicon Solution Inc. – 16 Megabit Serial Flash Memory with 4Kbyte Uniform Sector

EN25Q16
Table 11.100MHz AC Characteristics
(T_a = - 40°C to 85°C; V_CC = 2.7-3.6V)
Symbol Alt
Parameter
Serial Clock Frequency for:
FAST_READ, PP, SE, BE, DP, RES, WREN,
F_R
f_C
WRDI, WRSR
Serial Clock Frequency for:
RDSR, RDID, Dual Fast Read, Dual I/O and
Quad I/O Fast Read
f_R
Serial Clock Frequency for READ
t_CH ¹
Serial Clock High Time
t_CL1
Serial Clock Low Time
t_CLCH2
t_CHCL ²
Serial Clock Rise Time (Slew Rate)
Serial Clock Fall Time (Slew Rate)
t_SLCH
t_{CSS CS# Active Setup Time}
t_CHSH
CS# Active Hold Time
t_SHCH
CS# Not Active Setup Time
t_CHSL
CS# Not Active Hold Time
Min Typ
D.C.
D.C.
D.C.
4
4
0.1
0.1
5
5
5
5
Max
100
80
50
t_SHSL
t_CSH
CS# High Time for read
CS# High Time for program/erase
15
50
t_SHQZ ²
t_{DIS Output Disable Time}
6
t_CLQX
t_{HO Output Hold Time}
0
t_DVCH
t_{DSU Data In Setup Time}
2
t_CHDX
t_{DH Data In Hold Time}
5
t_CLQV
t_V
Output Valid from CLK
8
t_WHSL3
Write Protect Setup Time before CS# Low
20
t_SHWL3
Write Protect Hold Time after CS# High
100
t_DP ²
CS# High to Deep Power-down Mode
3
t_RES1 ²
CS# High to Standby Mode without Electronic
Signature read
3
t_RES2 ²
CS# High to Standby Mode with Electronic
Signature read
1.8
t_W
Write Status Register Cycle Time
10
15
t_PP
Page Programming Time
1.3
5
t_SE
Sector Erase Time
0.09
0.3
t_BE
Block Erase Time
0.4
2
t_CE
Chip Erase Time
12
35
Note: 1. t_CH + t_CL must be greater than or equal to 1/ f_C
2. Value guaranteed by characterization, not 100% tested in production.
3. Only applicable as a constraint for a Write status Register instruction when Status Register Protect Bit is set at 1
Unit
MHz
MHz
MHz
ns
ns
V / ns
V / ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
µs
µs
µs
ms
ms
s
s
s
This Data Sheet may be revised by subsequent versions
30
or modifications due to changes in technical specifications.
©2004 Eon Silicon Solution, Inc.,
Rev. E, Issue Date: 2009/10/21
www.eonssi.com