English
Language : 

EN25P32 Datasheet, PDF (26/34 Pages) Eon Silicon Solution Inc. – 32 Mbit Uniform Sector, Serial Flash Memory
EN25P32
Table 12. 75MHz AC Characteristics
(Ta = 0°C to 70°C or – 40°C to 85°C; VCC = 2.7-3.6V)
Symbol
FR
Alt
fC
Parameter
Serial Clock Frequency for:
FAST_READ, PP, SE, BE, DP, RES, WREN,
WRDI, RDSR, WRSR
fR
Serial Clock Frequency READ instruction
tCLH 1
Serial Clock High Time
tCLL1
Serial Clock Low Time
tCLCH2
Serial Clock Rise Time (Slew Rate)
tCHCL 2
Serial Clock Fall Time (Slew Rate)
tSLCH
tCSS CS# Active Setup Time
tCHSH
CS# Active Hold Time
tSHCH
CS# Not Active Setup Time
tCHSL
CS# Not Active Hold Time
tSHSL
tCSH CS# High Time
tSHQZ 2
tDIS Output Disable Time
tCLQX
tHO Output Hold Time
tDVCH
tDSU Data In Setup Time
tCHDX
tDH Data In Hold Time
tHLCH
HOLD# Low Setup Time ( relative to SCK )
tHHCH
HOLD# High Setup Time ( relative to SCK )
tCHHH
HOLD# Low Hold Time ( relative to SCK )
tCHHL
HOLD# High Hold Time ( relative to SCK )
tHLQZ 2
tHZ HOLD# Low to High-Z Output
tHHQZ 2
tLZ HOLD# High to Low-Z Output
tCLQV
tV
Output Valid from SCK
tWHSL3
Write Protect Setup Time before CS# Low
tSHWL3
Write Protect Hold Time after CS# High
tDP 2
CS# High to Deep Power-down Mode
tRES1 2
tRES2 2
CS# High to Standby Mode without Electronic
Signature read
CS# High to Standby Mode with Electronic
Signature read
tW
Write Status Register Cycle Time
tPP
Page Programming Time
tSE
Sector Erase Time 64KB sectors
tBE
Bulk Erase Time
Min
Typ
D.C.
D.C.
6
6
0.1
0.1
5
5
5
5
100
0
2
5
5
5
5
5
20
100
10
1.5
0.8
25
Max
75
66
6
6
6
6
3
3
1.8
15
5
2
50
Note: 1. TSCKH + TSCKL must be greater than or equal to 1/ FCLK
2. Value guaranteed by characterization, not 100% tested in production.
3. Only applicable as a constraint for a Write status Register instruction when Sector Protect Bit is set at 1.
Unit
MHz
MHz
ns
ns
V / ns
V / ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
µs
µs
µs
ms
ms
s
s
This Data Sheet may be revised by subsequent versions 26 ©2004 Eon Silicon Solution, Inc., www.essi.com.tw
or modifications due to changes in technical specifications.
Rev. C, Issue Date: 2007/10/18