EN25S80A Datasheet, PDF (22/66 Pages) Eon Silicon Solution Inc. – 8 Megabit 1.8V Serial Flash Memory with 4Kbyte Uniform Sector

EN25S80A
Figure 11.1 Write Status Register Instruction Sequence under EQPI Mode
Read Data Bytes (READ) (03h)
The device is first selected by driving Chip Select (CS#) Low. The instruction code for the Read Data
Bytes (READ) instruction is followed by a 3-byte address (A23-A0), each bit being latched-in during the
rising edge of Serial Clock (CLK). Then the memory contents, at that address, is shifted out on Serial
Data Output (DO), each bit being shifted out, at a maximum frequency fR, during the falling edge of
Serial Clock (CLK).
The instruction sequence is shown in Figure 12. The first byte addressed can be at any location. The
address is automatically incremented to the next higher address after each byte of data is shifted out.
The whole memory can, therefore, be read with a single Read Data Bytes (READ) instruction. When
the highest address is reached, the address counter rolls over to 000000h, allowing the read sequence
to be continued indefinitely.
The Read Data Bytes (READ) instruction is terminated by driving Chip Select (CS#) High. Chip Select
(CS#) can be driven High at any time during data output. Any Read Data Bytes (READ) instruction,
while an Erase, Program or Write cycle is in progress, is rejected without having any effects on the
cycle that is in progress.
This Data Sheet may be revised by subsequent versions
22
or modifications due to changes in technical specifications.
©2014 Eon Silicon Solution, Inc.,
Rev. J, Issue Date: 2014/01/20
www.eonssi.com