EN25F10_1 Datasheet, PDF (22/32 Pages) Eon Silicon Solution Inc. – 1 Megabit Serial Flash Memory with 4Kbytes Uniform Sector

EN25F10
Figure 19. Read Identification (RDID)
Enter OTP Mode (3Ah)
This Flash has an extra 256 bytes OTP sector, user must issue ENTER OTP MODE command to read,
program or erase OTP sector. After entering OTP mode, the OTP sector is mapping to sector 31; SRP
bit becomes OTP_LOCK bit and can be read with RDSR command. Program / Erase command will be
disabled when OTP_LOCK bit is ‘1’
WRSR command will ignore the input data and program OTP_LOCK bit to 1.
User must clear the protect bits before enter OTP mode.
OTP sector can only be programmed and erased before OTP_LOCK bit is set to ‘1’ and BP [2:0] = ‘000’.
In OTP mode, user can read other sectors, but programming /erasing other sectors are only allowed
when OTP_LOCK bit equal ‘0’.
User can use WRDI (04h) commands to exit OTP mode.
Erase OTP Command (20h)
User can use Sector Erase (20h) command only to erase OTP data.
Table 7. OTP Sector Address
Sector
31
Sector Size
256 byte
Address Range
01F000h – 01F0FFh
Note: The OTP sector is mapping to sector 31
This Data Sheet may be revised by subsequent versions
22
or modifications due to changes in technical specifications.
©2004 Eon Silicon Solution, Inc.,
Rev. E, Issue Date: 2010/05/25
www.eonssi.com