HPR12K-00 Datasheet, PDF (1/6 Pages) Emerson Network Power – Connecting the input power cable, output load cable and communication wire according to the below figure.

Operating Instructions
HPR12K-00
Embedded Power for
Business-Critical Continuity
Rev.06.09.10
HPR12K-00
1 of 6
1. General Install
Connecting the input power cable, output load cable and communication wire according
to the below figure.
Aux. DC
Output
AC INPUT
AC INPUT
Main DC Output
AC INPUT
AC INPUT
Main DC Output
I2C/PMBus
Communication
AC Line Input
2. General Settings
Unless otherwise specified, when the PSON# switch is de-asserted (48V o/p is disabled).
It is means Manual ON/OFF DIP switch SW1 should be default according to below table.
And It must be checked before shipping.
Power Supplies
Status
DIP switch SW1 setting as a default
PSU 1#
PSU 2#
PSU 3#
CH 1 CH 2 CH 3 CH 4 CH 5 CH 6
PSU 4#
CH 7 CH8
OFF
Up
Down
Up
Down
Up
Down
Up
Down
Note 1. The status Down means set to ON position. The status UP means set to OFF position.
Note 2. Programming Switch SW1 default settings:
PSON switches : OFF
PSKILL switches : ON