GD25LQ40 Datasheet, PDF (4/59 Pages) ELM Electronics – 1.8V Uniform Sector Dual and Quad Serial Flash

GD25LQ40xIGx 1.8V Uniform Sector Dual and Quad Serial Flash
1. FEATURES
http://www.elm-tech.com
♦ 4M-bit Serial Flash
♦ Program/Erase Speed
- 512K-byte
- 256 bytes per programmable page
♦ Standard, Dual, Quad SPI, QPI
- Standard SPI: SCLK, CS#, SI, SO, WP#, HOLD#
- Dual SPI: SCLK, CS#, IO0, IO1, WP#, HOLD#
- Quad SPI: SCLK, CS#, IO0, IO1, IO2, IO3
- QPI: SCLK, CS#, IO0, IO1, IO2, IO3
♦ High Speed Clock Frequency
- 120MHz for fast read with 30PF load
- Dual I/O Data transfer up to 240Mbits/s
- Quad I/O Data transfer up to 480Mbits/s
- QPI Mode Data transfer up to 480Mbits/s
- Continuous Read With 8/16/32/64-byte Wrap
♦ Software/Hardware Write Protection
- Write protect all/portion of memory via software
- Enable/Disable protection with WP# pin
- Top or Bottom, Sector or Block selection
- Page Program time: 0.4ms typical
- Sector Erase time: 60ms typical
- Block Erase time: 0.3/0.5s typical
- Chip Erase time: 4s typical
♦ Flexible Architecture
- Sector of 4K-byte
- Block of 32/64K-byte
- Erase/Program Suspend/Resume
♦ Low Power Consumption
- 20mA maximum active current
- 5μA maximum power down current
♦ Advanced security Features
- 4*256-Byte Security Registers With OTP Lock
♦ Single Power Supply Voltage
- Full voltage range: 1.65~1.95V
♦ Minimum 100,000 Program/Erase Cycles
59 - 4
Rev.1.0