DRP024V060W1AZ_12 Datasheet, PDF (7/11 Pages) Delta Electronics, Inc. – CliQ DIN Rail Power Supply

TECHNICAL DATASHEET
CliQ DIN Rail Power Supply
24V 60W 1 Phase / DRP024V060W1AZ
Output De-rating VS. Input Voltage
■No output power de-rating across the entire input
voltage range
Assembly & Installation
The power supply unit (PSU) can be mounted on 35mm DIN rails in accordance with EN60715. The device should be installed with input
terminal blocks at the bottom.
Each device is delivered ready to install.
Mounting
Dismounting
Fig. 2.1 Mounting
Snap on the DIN rail as shown in Fig. 2.1:
1. Tilt the unit upwards and insert it onto the DIN rail.
2. Push downwards until stopped.
3. Press against the bottom front side for locking.
4. Shake the unit slightly to ensure that it is secured.
Fig. 2.2 Dismounting
To uninstall, pull or slide down the latch with screw driver as
shown in Fig 2.2. Then slide the power supply unit (PSU) in
the opposite direction, release the latch and pull out the
power supply unit (PSU) from the rail.
7
All parameters are specified at 25°C ambient unless otherwise noted.
www.DeltaPSU.com (December 2012, Rev. 02)