DS2156 Datasheet, PDF (209/262 Pages) Dallas Semiconductor – T1/E1/J1 Single-Chip Transceiver TDM/UTOPIA II Interface

DS2156
Register Name:
Register Description:
Register Address:
BIC
BERT Interface Control Register
EAh
Bit #
7
6
5
4
3
2
1
0
Name
—
RFUS
—
TBAT TFUS — BERTDIR BERTEN
Default
0
0
0
0
0
0
0
0
Bit 0/BERT Enable (BERTEN)
0 = BERT disabled
1 = BERT enabled
Bit 1/BERT Direction (BERTDIR)
0 = network
BERT transmits toward the network (TTIP and TRING) and receives from the network (RTIP and
RRING). The BERT pattern can be looped back to the receiver internally by using the framer loopback
function.
1 = system
BERT transmits toward the system backplane (RSER) and receives from the system backplane (TSER).
Bits 2, 5, 7/Unused, must be set to 0 for proper operation
Bit 3/Transmit Framed/Unframed Select (TFUS)
0 = BERT does not source data into the F-bit position (framed)
1 = BERT does source data into the F-bit position (unframed)
Bit 4/Transmit Byte-Align Toggle (TBAT). A 0-to-1 transition forces the BERT to byte align its pattern with the
transmit formatter. This bit must be transitioned in order to byte align the Daly pattern.
Bit 6/Receive Framed/Unframed Select (RFUS)
0 = BERT is not sent data from the F-bit position (framed)
1 = BERT is sent data from the F-bit position (unframed)
209 of 262