DS1339 Datasheet, PDF (16/18 Pages) Dallas Semiconductor – Serial Real-Time Clock

DS1339 I²C Serial Real-Time Clock
Each data transfer is initiated with a START condition and terminated with a STOP condition. The number of data
bytes transferred between START and STOP conditions is not limited, and is determined by the master device.
The information is transferred byte-wise and each receiver acknowledges with a ninth bit.
Acknowledge: Each receiving device, when addressed, is obliged to generate an acknowledge after the reception
of each byte. The master device must generate an extra clock pulse that is associated with this acknowledge bit.
A device that acknowledges must pull down the SDA line during the acknowledge clock pulse in such a way that
the SDA line is stable LOW during the HIGH period of the acknowledge related clock pulse. Of course, setup and
hold times must be taken into account. A master must signal an end of data to the slave by not generating an
acknowledge bit on the last byte that has been clocked out of the slave. In this case, the slave must leave the data
line HIGH to enable the master to generate the STOP condition.
Figure 8. Data Transfer on I²C Serial Bus
Depending upon the state of the R/W bit, two types of data transfer are possible:
1) Data transfer from a master transmitter to a slave receiver. The first byte transmitted by the master is the
slave address. Next follows a number of data bytes. The slave returns an acknowledge bit after each received
byte. Data is transferred with the most significant bit (MSB) first.
2) Data transfer from a slave transmitter to a master receiver. The first byte (the slave address) is transmitted
by the master. The slave then returns an acknowledge bit. This is followed by the slave transmitting a number
of data bytes. The master returns an acknowledge bit after all received bytes other than the last byte. At the
end of the last received byte, a “not acknowledge” is returned. The master device generates all of the serial
clock pulses and the START and STOP conditions. A transfer is ended with a STOP condition or with a
repeated START condition. Since a repeated START condition is also the beginning of the next serial transfer,
the bus is not released. Data is transferred with the most significant bit (MSB) first.
The DS1339 can operate in the following two modes:
1) Slave Receiver Mode (Write Mode): Serial data and clock are received through SDA and SCL. After each
byte is received an acknowledge bit is transmitted. START and STOP conditions are recognized as the
beginning and end of a serial transfer. Address recognition is performed by hardware after reception of the
slave address and direction bit (Figure 9). The slave address byte is the first byte received after the START
condition is generated by the master. The slave address byte contains the 7-bit DS1339 address, which is
1101000, followed by the direction bit (R/W), which is 0 for a write. After receiving and decoding the slave
address byte the slave outputs an acknowledge on the SDA line. After the DS1339 acknowledges the slave
address + write bit, the master transmits a register address to the DS1339. This sets the register pointer on the
DS1339, with the DS1339 acknowledging the transfer. The master may then transmit zero or more bytes of
16 of 18