ES218 Datasheet, PDF (23/26 Pages) Cyrustek corporation – 2000 Counts Manual DMM

ES218
2000 Counts Manual DMM
LCD Annunciator
Condition
V
In voltage measurement mode, and diode measurement mode.
A
In current measurement mode.
Ω
In resistance measurement mode, and continuity mode.
F
In capacitance measurement mode.
m₁
In capacitor measurement mode and the full scale range is in the order of mF.
µ₁
In capacitor measurement mode and the full scale range is in the order of uF.
n
In capacitor measurement mode and the full scale range is in the order of nF.
In continuity check mode.
In diode mode.
Hz
In frequency mode.
ADP
When ADP0-3 mode is active.
DC
In DC voltage or DC current mode.
AC
In AC voltage or AC current mode.
AUTO
When automatic full scale range selection is enabled. (Hz or Cap Auto mode)
HOLD
When HOLD function is enabled.
MAX
When MAX function is enabled.
MIN
When MIN function is enabled.
m₂
In voltage or current measurement mode and the full scale range is in the order of 10^-3.
µ₂
In current measurement mode and the full scale range id in the order of uA.
M
In resistance measurement mode and the full scale range is in the order of MΩ.
K
In resistance measurement mode and the full scale range is in the order of KΩ.
℃
In temperature measurement mode and when the unit is℃ .
℉
In temperature measurement mode and when the unit is℉ .
(HV)
When the reading is exceeding default hazardous live voltage or OL in DCV or ACV,
or not proper voltage applied on Res/Cap/Diode/Hz modes, the HV warning symbol
will be displayed.
APO
LBAT
When auto power off function is enabled.
When battery voltage is too low
V 1.5
23
2015/12/11