CY14E108L Datasheet, PDF (9/20 Pages) Cypress Semiconductor – 8 Mbit (1024K x 8/512K x 16) nvSRAM

ADVANCE
CY14E108L, CY14E108N
AC Switching Characteristics
In the following table, the AC switching characteristics are listed.
Parameters
Cypress
Alt
Parameters Parameters
SRAM Read Cycle
t_ACE
t_RC[10]
t_AA[11]
t_ACS
t_RC
t_AA
t_DOE
t_OE
t_OHA
t_LZCE[12]
t_HZCE[12]
t_LZOE[12]
t_HZOE[12]
t_PU[10]
t_PD[10]
t_OH
t_LZ
t_HZ
t_OLZ
t_OHZ
t_PA
t_PS
t_DBE
-
t_LZBE
-
t_HZBE
-
SRAM Write Cycle
t_WC
t_WC
t_PWE
t_WP
t_SCE
t_CW
t_SD
t_DW
t_HD
t_DH
t_AW
t_AW
t_SA
t_AS
t_HA
t_HZWE[12,13]
t_LZWE[12]
t_WR
t_WZ
t_OW
t_BW
-
Description
Chip Enable Access Time
Read Cycle Time
Address Access Time
Output Enable to Data Valid
Output Hold After Address Change
Chip Enable to Output Active
Chip Disable to Output Inactive
Output Enable to Output Active
Output Disable to Output Inactive
Chip Enable to Power Active
Chip Disable to Power Standby
Byte Enable to Data Valid
Byte Enable to Output Active
Byte Disable to Output Inactive
Write Cycle Time
Write Pulse Width
Chip Enable To End of Write
Data Setup to End of Write
Data Hold After End of Write
Address Setup to End of Write
Address Setup to Start of Write
Address Hold After End of Write
Write Enable to Output Disable
Output Active after End of Write
Byte Enable to End of Write
20 ns
Min Max
25 ns
Min Max
45 ns
Unit
Min Max
20
25
45 ns
20
25
45
ns
20
25
45 ns
10
12
20 ns
3
3
3
ns
3
3
3
ns
8
10
15 ns
0
0
0
ns
8
10
15 ns
0
0
0
ns
20
25
45 ns
10
12
20 ns
0
0
0
ns
8
10
15 ns
20
25
45
ns
15
20
30
ns
15
20
30
ns
8
10
15
ns
0
0
0
ns
15
20
30
ns
0
0
0
ns
0
0
0
ns
8
10
15 ns
3
3
3
ns
15
20
30
ns
Notes
10. WE must be HIGH during SRAM read cycles.
11. Device is continuously selected with CE and OE both LOW.
12. Measured ±200 mV from steady state output voltage.
13. If WE is LOW when CE goes LOW, the output goes into high impedance state.
Document Number: 001-45524 Rev. *A
Page 9 of 20
[+] Feedback