CYW20715 Datasheet, PDF (34/47 Pages) Cypress Semiconductor – Bluetooth 4.0 + EDR compliant

CYW20715
Table 18. Receiver RF Specifications (Cont.)
Parameter
Conditions
Minimum Typical ^a
Out-of-Band Blocking Performance (CW) ^d
30 MHz–2000 MHz
0.1% BER
–
–10.0
2000–2399 MHz
0.1% BER
–
–27
2498–3000 MHz
0.1% BER
–
–27
3000 MHz–12.75 GHz
0.1% BER
–
–10.0
Out-of-Band Blocking Performance, Modulated Interferer
776–764 MHz
CDMA
–
–15
824–849 MHz
CDMA
–
–15
1850–1910 MHz
CDMA
–
–20
824–849 MHz
EDGE/GSM
–
–10
880–915 MHz
EDGE/GSM
–
–10
1710–1785 MHz
EDGE/GSM
–
–15
1850–1910 MHz
EDGE/GSM
–
–15
1850–1910 MHz
WCDMA
–
–25
1920–1980 MHz
WCDMA
–
–25
Intermodulation Performance ^e
BT, Df = 5 MHz
–
–39.0
–
Spurious Emissions ^f
30 MHz to 1 GHz
–
–
–
1 GHz to 12.75 GHz
–
–
–
65 MHz to 108 MHz
FM Rx
–
–145
746 MHz to 764 MHz
CDMA
–
–145
851–894 MHz
CDMA
–
–145
925–960 MHz
EDGE/GSM
–
–145
1805–1880 MHz
EDGE/GSM
–
–145
1930–1990 MHz
PCS
–
–145
2110–2170 MHz
WCDMA
–
–145
Maximum Unit
–
dBm
–
dBm
–
dBm
–
dBm
–
dBm
–
dBm
–
dBm
–
dBm
–
dBm
–
dBm
–
dBm
–
dBm
–
dBm
–
dBm
–57
dBm
–47
dBm
–
dBm/Hz
–
dBm/Hz
–
dBm/Hz
–
dBm/Hz
–
dBm/Hz
–
dBm/Hz
–
dBm/Hz
a. Typical operating conditions are 1.22V operating voltage and 25°C ambient temperature.
b. The receiver sensitivity is measured at BER of 0.1% on the device interface.
c. Measured with the dirty transmitter OFF. Typically, there is approximately 1 dB less in Rx sensitivity when the dirty transmitter is ON.
d. Meets this specification using front-end band pass filter.
e. f0 = -64 dBm Bluetooth-modulated signal, f1 = –39 dBm sine wave, f2 = –39 dBm Bluetooth-modulated signal, f0 = 2f1 – f2, and |f2 – f1| = n*1 MHz, where n is 3, 4,
or 5. For the typical case, n = 5.
f. Includes baseband radiated emissions.
Note:
■ All specifications in Table 19 are referenced to commercial temperatures. For details, see Table 17 on page 33.
■ All specifications in Table 19 are single-ended. Unused input are left open.
Document Number: 002-14813 Rev. *B
Page 34 of 47