CYII5SM1300AB_11 Datasheet, PDF (32/35 Pages) Cypress Semiconductor – IBIS5 1.3 Megapixel CMOS Image Sensor

CYII5SM1300AB
Glass Lid
The IBIS5-B-1300 image sensor uses a glass lid without any coatings. Figure 31 shows the transmission characteristics of the glass
lid. As seen in Figure 31, the sensor does not use infrared attenuating color filter glass. Provide a filter in the optical path when using
color devices.
Figure 31. Transmission Characteristics of Glass Lid
Handling Precautions
For proper handling and storage conditions, refer to the Cypress
application note AN52561, Image Sensor Handling and Best
Practices, at www.cypress.com.
Information on Pb-Free Soldering
IBIS5-B-1300-M2 (serial numbers beyond 3694): the product
was tested successfully for Pb-free soldering processes, using a
reflow temperature profile with maximum 260°C, minimum 40s
at 255°C and minimum 90s at 217°C.
Limited Warranty
Cypress Image Sensor Business Unit warrants that the image
sensor products to be delivered hereunder if properly used and
serviced, will conform to Seller's published specifications and will
be free from defects in material and workmanship for one (1)
year following the date of shipment. If a defect were to manifest
itself within 1 (one) year period from the sale date, Cypress will
either replace the product or give credit for the product.
Return Material Authorization (RMA)
Cypress packages all of its image sensor products in a clean
room environment under strict handling procedures and ships all
image sensor products in ESD-safe, clean room-approved
shipping containers. Products returned to Cypress for failure
analysis should be handled under these same conditions and
packed in its original packing materials, or the customer may be
liable for the product.
RoHS (Pb-free) Compliance
This paragraph reports the use of hazardous chemical
substances as required by the RoHS Directive (excluding
packing material).
Lead, Cadmium, Mercury Hexavalent Chromium, PBB (Polybro-
minated biphenyls), PBDE (Polybrominated diphenyl ethers),
noted as “intentional content: is not available in the
IBIS5-B-1300.
Note ‘Intentional content’ is defined as any material demanding
special attention that is allowed into the product as follows:
■ A chemical composition is added into the inquired product
intentionally to produce and maintain the required performance
and function of the product.
■ A chemical composition which is used intentionally in the
manufacturing process, that is allowed into the product.
The following case is not treated as ‘intentional content’:
■ The above material is contained as an impurity into raw
materials or parts of the intended product. The impurity is
defined as a substance that cannot be removed industrially, or
it is produced using a process such as chemical composing or
reaction, and it cannot be removed technically.
Document #: 38-05710 Rev. *H
Page 32 of 35
[+] Feedback