W180_05 Datasheet, PDF (2/10 Pages) Cypress Semiconductor – Peak Reducing EMI Solution

W180
Pin Definitions
Pin Name
Pin No.
Pin
Type
Pin Description
CLKOUT
5
O Output Modulated Frequency: Frequency modulated copy of the unmodulated
input clock (SSON# asserted).
CLKIN or X1
1
I Crystal Connection or External Reference Frequency Input: This pin has dual
functions. It may either be connected to an external crystal, or to an external reference
clock.
NC or X2
2
I Crystal Connection: Input connection for an external crystal. If using an external
reference, this pin must be left unconnected.
SSON#
8 (-02, -03 52, 53) I Spread Spectrum Control (Active LOW): Asserting this signal (active LOW) turns
the internal modulation waveform on. This pin has an internal pull-down resistor.
FS1:2
7, 8 (-01, 51)
I Frequency Selection Bit(s) 1 and 2: These pins select the frequency range of
operation. Refer to Table 2. These pins have internal pull-up resistors.
SS%
4
I Modulation Width Selection: When Spread Spectrum feature is turned on, this pin
is used to select the amount of variation and peak EMI reduction that is desired on
the output signal. Internal pull-up resistor.
VDD
6
P Power Connection: Connected to 3.3V or 5V power supply.
GND
3
G Ground Connection: This should be connected to the common ground plane.
Document #: 38-07156 Rev. *B
Page 2 of 10