DS-72-11 Datasheet, PDF (14/14 Pages) Cymbet Corporation – Charge Pump and Battery Management ASIC Bare Die

CBC910 Die Pad Locations
CBC910
VDD
VBAT
ENABLE
VMODE
GND
VOUT
RESET/
CP
CN
Trim4
51.35
707.3
Notes:
1) All dimensions measured to the center of the respective bond pad and measured relative to the lower left
corner of metal-2 on the Trim4 pad as shown below. That Trim4 coordinate is the 0,0 reference point for the data
extents of the die. Total die size is 150um larger in x and y as defined by the street width.
2) Die size to center of scribe is 960um (x) by 1360um (y).
3) Drawing not to scale. All dimensions in microns.
Ordering Information
EnerChip CC Part Number
CBC910-BDC-WP
CBC910-BGC-WP
CBC910-WAF
Description
CBC910 Bare Die Wirebond Pad
CBC910 Bare Die Gold Bumped
CBC910 Bare Die
Notes
Shipped in Waffle Pack
Shipped in Waffle Pack
Shipped as Wafer
Disclaimer of Warranties; As Is
The information provided in this data sheet is provided “As Is” and Cymbet Corporation disclaims all representations or warranties of any
kind, express or implied, relating to this data sheet and the Cymbet battery product described herein, including without limitation, the
implied warranties of merchantability, fitness for a particular purpose, non-infringement, title, or any warranties arising out of course of
dealing, course of performance, or usage of trade. Cymbet battery products are not approved for use in life critical applications. Users shall
confirm suitability of the Cymbet battery product in any products or applications in which the Cymbet battery product is adopted for use and
are solely responsible for all legal, regulatory, and safety-related requirements concerning their products and applications and any use of
the Cymbet battery product described herein in any such product or applications.
Cymbet, the Cymbet Logo, and EnerChip are Cymbet Corporation Trademarks
©2012-2014 Cymbet Corporation • Tel: [phone] • www.cymbet.com
DS-72-11 Rev A

Page 14 of 14