CMPA0060025F Datasheet, PDF (6/11 Pages) Cree, Inc – 25 W, 20 MHz-6000 MHz, GaN MMIC Power Amplifier

General Device Information
The CMPA0060025F is a GaN HEMT MMIC Power Amplifier, which operates between 20 MHz - 6.0 GHz.The amplifier typi-
cally provides 17 dB of small signal gain and 25 W saturated output power with an associated power added efficiency of better than 20
%. The wideband amplifier’s input and output are internally matched to 50 Ohm. The amplifier requires bias from appropriate Bias-T’s,
through the RF input and output ports.
The CMPA0060025F is provided in a flange package format. The input and output connections are gold plated to enable gold
bond wire attach at the next level assembly.
The measurements in this data sheet were taken on devices wire-bonded to the test fixture with 2 mil gold bond wires. The
CMPA0060025F-AMP1 and the device were then measured using external Bias-T’s, (TECDIA: AMP1T-H06M20 or similar), as shown in
Figure 2. The Bias-T’s were included in the calibration of the test system. All other losses associated with the test fixture are included in
the measurements.
V_GG
V_DD
RF In
RF Out
Input Bias T
Output Bias T
CMMPPAA205066000252F mounted
in the test fixture
Figure 2. Typical test system setup required for measuring CMPA0060025F-AMP1
Copyright © 2009-2015 Cree, Inc. All rights reserved. The information in this document is subject to change without notice. Cree and the Cree logo are
registered trademarks of Cree, Inc. Other trademarks, product and company names are the property of their respective owners and do not imply specific
product and/or vendor endorsement, sponsorship or association.
6
CMPA0060025F Rev 4.0
Cree, Inc.
4600 Silicon Drive
Durham, North Carolina, USA 27703
USA Tel: [phone]
Fax: [phone]
www.cree.com/rf