|
HBS2KGB4SP011C Datasheet, PDF (2/6 Pages) ITT Industries – Single Pole Standard Precision Snap-acting Switches | |||
|
◁ |
HB Series
Single Pole Standard Precision Snap-acting Switches
Sealed Actuator and Case
To provide reliable service under environmental conditions that might damage standard precision switches, various HB Series
switch models are sealed against the entrance of airborne contaminants and/or splashing liquids. The clearance between
the operating plunger and the cover is sealed with a silicone boot and the base cover joint is sealed with an epoxy adhesive.
These models are designed to meet requirements of IP65 (dust proof, water splash and dew condensation). For additional
information on sealed switches, consult our Customer Service Center.
HB PRECISION SNAP-ACTING SWITCHES
SERIES
S SINGLE POLE SWITCH
FUNCTION
J
OPER. POS.
.625 ± .015
(15,88 ± 0,38)
Single Pole
NOTE: To select switching function, see CIRCUITRY section, page J-52.
CONTACT SEPARATION
OPTION
CODE
2
1
4
7
NOMINAL CONTACT
SEPARATION (in./mm)
.020
(0,51)
.010
(0,25)
.040
(1,02)
.070
(1,78)
Switches with 1 AMP rating (option
code âF5â) are available only with
.020 contact separation (option â2â).
Switches with 1/2 HP, 125 V AC rating
or greater (option codes âB5 and B6â)
are not available with .010 contact
separation (option code â1â).
.0004
.0002
CONTACT
SEPARATION
0
1
2
4
7
DIFFERENTIAL TRAVEL SPECIFICATION LIMITS
FOR VARIOUS CONTACT SEPARATIONS
INCH
.001
.002
.003
.004
.005
.0015
Jâ50
Dimensions are shown: Inch (mm)
Specifications and dimensions subject to change
www.ck-components.com
|
▷ |