CS4207-CNZ Datasheet, PDF (131/148 Pages) Cirrus Logic – Low-power, 4-in / 6-out HD Audio Codec with Headphone Amp

Bits
Type
Default
4:3
Read/Write
01b
2
Read/Write
0b
1
Read/Write
0b
0
Read/Write
0b
6.15.6.3 ADC Configuration (CIR = 0002h)
Bits
Type
Default
15
Read/Write
0b
14
Read/Write
0b
13
Read/Write
0b
CS4207
Description
HOLD[1:0] – Determines how received AES3
audio sample is affected when an receive error
occurs. The errors that affect hold behavior are
parity, bi-phase and confidence. HOLD has no
effect in Raw S/PDIF RX Data Mode.
00 - hold last audio sample.
01 - replace the current audio sample with all
zeros (mute).
10 - do not change the received audio sample.
11 - reserved
TRUNC – Determines if the audio word length is
set according to the incoming channel status
data as decoded by the AUX[3:0] bits. The
resulting word length in bits is 24 minus
AUX[3:0]. The TRUNC function is valid only on
PCM audio data.
0 – Incoming data is not truncated.
1 – Incoming data is truncated according to the
length specified in the channel status data.
TRUNC has no effect on output data if detected
as being non-audio.
SRC_MUTE – When SRC_MUTE is set to ‘1’,
the SRC will soft-mute when it loses lock and soft
unmute when it regains lock.
0 - Soft mute disabled
1 - Soft mute enabled
Reserved
Description
URG (Unsolicited Response Gating): This bit
allows unsolicited responses to be gated.
0 - Normal propagation of unsolicited responses.
1 - Unsolicited responses are gated if AFG is in
D3.
ADC2 Gain: This bit adjusts the gain of the Mic
In 1/Line In 2 path for the given input topology.
0 - 6 dB gain added (pseudo-differential and sin-
gle-ended mode).
1 - no gain added (fully differential mode).
Note: This bit is OR’ed with the BTL bit in the Mic
In 1/Line In 2 EAPD/BTL Enable Control.
ADC1 Gain: This bit adjusts the gain of the Line
In 1/Mic In 2 path for the given input topology.
0 - 6 dB gain added (pseudo-differential and sin-
gle-ended mode).
1 - no gain added (not supported - test only).
DS880F4
131