CAT24FC32A Datasheet, PDF (2/12 Pages) Catalyst Semiconductor – 32K-Bit Fast Mode I2C Serial CMOS EEPROM

CAT24FC32A
PIN FUNCTIONS
Pin Name
Function
A0, A1, A2 Device Address Inputs
SDA
Serial Data/Address
SCL
Serial Clock
WP
Write Protect
VCC
Power Supply
VSS
Ground
ABSOLUTE MAXIMUM RATINGS*
Temperature Under Bias ................. –55°C to +125°C
Storage Temperature ....................... –65°C to +150°C
Voltage on Any Pin with
Respect to Ground⁽¹⁾ ........... –2.0V to +V_CC + 2.0V
V_CC with Respect to Ground ............... –2.0V to +7.0V
Package Power Dissipation
Capability (T_A = 25°C) ................................... 1.0W
Lead Soldering Temperature (10 secs) ............ 300°C
Output Short Circuit Current⁽²⁾ ........................ 100mA
*COMMENT
Stresses above those listed under “Absolute Maximum
Ratings” may cause permanent damage to the device.
These are stress ratings only, and functional operation of
the device at these or any other conditions outside of those
listed in the operational sections of this specification is not
implied. Exposure to any absolute maximum rating for
extended periods may affect device performance and
reliability.
RELIABILITY CHARACTERISTICS
Symbol
Parameter
Min.
N_END(3)
TDR(3)
V_ZAP(3)
ILTH(3)(4)
Endurance
Data Retention
ESD Susceptibility
Latch-up
1,000,000
100
2000
100
Max.
Units
Cycles/Byte
Years
Volts
mA
Reference Test Method
MIL-STD-883, Test Method 1033
MIL-STD-883, Test Method 1008
MIL-STD-883, Test Method 3015
JEDEC Standard 17
RECOMMENDED OPERATING CONDITIONS
Temperature Range Minimum
Maximum
Commercial
0˚C
+70˚C
Supply Voltage Range
1.8V to 3.6V
Device
CAT24FC32A
Note:
(1) The minimum DC input voltage is –0.5V. During transitions, inputs may undershoot to –2.0V for periods of less than 20 ns. Maximum DC
voltage on output pins is V_CC +0.5V, which may overshoot to V_CC + 2.0V for periods of less than 20ns.
(2) Output shorted for no more than one second. No more than one output shorted at a time.
(3) This parameter is tested initially and after a design or process change that affects the parameter.
(4) Latch-up protection is provided for stresses up to 100 mA on address and data pins from –1V to V_CC +1V.
Doc. No. 1048, Rev. F
2