CM2030 Datasheet, PDF (3/14 Pages) California Micro Devices Corp – HDMI Transmitter Port Protection and Interface Device

CM2030
PIN DESCRIPTIONS (CONTINUED)
38
3, 5, 8, 11,
14, 25,
28, 31, 34,
36
5V_OUT
GND / TMDS_GND
8kV³
N/A
55mA minimum overcurrent protected 5V output. This output must be
bypassed with a 0.1μF ceramic capacitor.
GND reference.
Note 1: These 2 pins need to be connected together in-line on the PCB. See recommended layout diagram.
Note 2: This output can be connected to an external 0.1μF ceramic capacitor/pads to maintain backward compatibility with the
CM2020.
Note 3: Standard IEC 61000-4-2, C_DISCHARGE=150pF, R_DISCHARGE=330Ω, 5V_SUPPLY and LV_SUPPLY within recommended
operating conditions, GND=0V, 5V_OUT (pin 38), and HOTPLUG_DET_OUT (pin 20) each bypassed with a 0.1μF ceramic
capacitor connected to GND.
Note 4: Human Body Model per MIL-STD-883, Method 3015, C_DISCHARGE=100pF, R_DISCHARGE=1.5kΩ, 5V_SUPPLYand
LV_SUPPLY within recommended operating conditions, GND=0V, 5V_OUT (pin 38), and HOTPLUG_DET_OUT (pin 20)
each bypassed with a 0.1μF ceramic capacitor connected to GND.
Note 5: These pins should be routed directly to the associated GND pins on the HDMI connector with single point ground vias at the
connector.
Note 6: The slew-rate control and active acceleration circuitry dynamically offsets the system capacitive load on these pins.
© 2007 California Micro Devices Corp. All rights reserved.
490 N. McCarthy Blvd., Milpitas, CA 95035-5112 ●Tel: [phone] ●Fax: [phone] ●www.cmd.com
3
Issue A – 11/16/07