English
Language : 

OPA2690 Datasheet, PDF (6/30 Pages) Burr-Brown (TI) – Dual, Wideband, Voltage-Feedback OPERATIONAL AMPLIFIER with Disable
OPA2690
SBOS238D − JUNE 2002 − REVISED DECEMBER 2004
www.ti.com
ELECTRICAL CHARACTERISTICS: VS = +5V (continued)
Boldface limits are tested at +25°C.
At RF = 402Ω, RL = 100Ω to VS/2, and G = +2 (see Figure 2 for AC performance only), unless otherwise noted.
TYP
OPA2690ID, I-14D
MIN/MAX OVER TEMPERATURE
PARAMETER
CONDITIONS
+25°C
+25°C(1)
0°C to −40°C to
70°C(2) +85°C(2)
UNITS
MIN/
MAX
TEST
LEVEL
(3)
DISABLE (SO-14 Only)
Power-Down Supply Current (+VS)
Off Isolation
Output Capacitance in Disable
Turn-On Glitch
Turn-Off Glitch
Enable Voltage
Disable Voltage
Control Pin Input Bias Current (VDIS)
POWER SUPPLY
Specified Single-Supply Operating Voltage
Maximum Single-Supply Operating Voltage
Maximum Quiescent Current (2 Channels)
Minimum Quiescent Current (2 Channels)
Power-Supply Rejection Ratio (+PSRR)
TEMPERATURE RANGE
Specification: D, 14D
Thermal Resistance, qJA
D
SO-8
14D SO-14
Disabled LOW
VDIS = 0, Both Channels
G = +2, 5MHz
G = +2, RL = 150Ω, VIN = VS/2
G = +2, RL = 150Ω, VIN = VS/2
VDIS = 0, Each Channel
VS = +5V
VS = +5V
Input-Referred
Junction-to-Ambient
−200
65
4
±50
±20
3.3
1.8
75
−400
−480
−520
3.5
3.6
3.7
1.7
1.6
1.5
130
150
160
µA
max
A
dB
typ
C
pF
typ
C
mV
typ
C
mV
typ
C
V
min
A
V
max
A
µA
typ
C
5
V
typ
C
12
12
12
V
max
B
9.8
10.88 11.44
12.1
mA
max
A
9.8
8.96
8.0
7.72
mA
min
A
72
dB
typ
C
−40 to +85
125
150
°C
typ
C
°C/W typ
C
°C/W typ
C
(1) Junction temperature = ambient for +25°C specifications.
(2) Junction temperature = ambient at low temperature limits; junction temperature = ambient +15°C at high temperature limit for over temperature specifications.
(3) Test levels: (A) 100% tested at +25°C. Over temperature limits by characterization and simulation. (B) Limits set by characterization and simulation. (C) Typical value only
for information.
(4) Current is considered positive out-of-node. VCM is the input common-mode voltage.
(5) Tested < 3dB below minimum specified CMRR at ± CMIR limits.
6