CS42436 Datasheet, PDF (1/66 Pages) Cirrus Logic – 108 dB, 192 kHz 6-in, 6-out TDM CODEC

CS42436
108 dB, 192 kHz 6-in, 6-out TDM CODEC
FEATURES
GENERAL DESCRIPTION
z Six 24-bit A/D, Six 24-bit D/A Converters
z ADC Dynamic Range
– 105 dB Differential
– 102 dB Single-ended
The CS42436 CODEC provides six multi-bit analog-to-digi-
tal and six multi-bit digital-to-analog Delta-sigma
converters. The CODEC is capable of operation with either
differential or single-ended inputs and outputs, in a 52-pin
MQFP package.
z DAC Dynamic Range
– 108 dB Differential
– 105 dB Single-ended
z ADC/DAC THD+N
– -98 dB Differential
Six fully differential, or single-ended, inputs are available on
stereo ADC1, ADC2, and ADC3. When operating in Single-
ended Mode, an internal MUX before ADC3 allows selec-
tion from up to four single-ended inputs. Digital volume
control is provided for each ADC channel, with selectable
overflow detection.
– -95 dB Single-ended
All six DAC channels provide digital volume control and can
z Compatible with Industry-standard Time
operate with differential or single-ended outputs.
Division Multiplexed (TDM) Serial Interface ^{An auxiliary serial input is available for an additional two}
z DAC Sampling Rates up to 192 kHz
channels of PCM data.
z ADC Sampling Rates up to 96 kHz
z Programmable ADC High-pass Filter for DC
Offset Calibration
z Logarithmic Digital Volume Control
The CS42436 is ideal for audio systems requiring wide dy-
namic range, negligible distortion and low noise, such as
A/V receivers, DVD receivers, and automotive audio
systems.
z Hardware Mode or Software I²C & SPI™
z Supports Logic Levels Between 5 V and
ORDERING INFORMATION
1.8 V
See page 63.
Control Port & Serial
Audio Port Supply =
1.8 V to 5 V
Digital Supply =
3.3 V
Hardware Mode or
I²C/SPI Software Mode
Control Data
Reset
Register
Configuration
Analog Supply =
3.3 V to 5 V
Internal Voltage
Reference
TDM Serial Audio
Input
Auxilliary Serial
Audio Input
Input Master
Clock
TDM Serial Audio
Output
Volume
Controls
Digital
Filters
∆Σ
Modulators
High Pass
Filter
High Pass
Filter
Digital
Filters
Digital
Filters
Multibit
6
DAC1-3 and
Analog Filters
6
Differential or
Single-Ended
Outputs
Multibit
Oversampling
ADC1&2
Multibit
Oversampling
ADC3
4
4
Differential or
Single-Ended
Analog Inputs
2
2
*Optional MUX allows selection from up to 4 single-ended inputs.
Preliminary Product Information
This document contains information for a new product.
Cirrus Logic reserves the right to modify this product without notice.
Cirrus Logic, Inc.
http://www.cirrus.com
Copyright © Cirrus Logic, Inc. 2005
(All Rights Reserved)
FEB ‘05
DS647PP2