AZPB70 Datasheet, PDF (5/15 Pages) Arizona Microtek, Inc – Programmer Board Kit for AZT70/71

Arizona Microtek, Inc.
AZPB70
Programmer Board for AZT70/71
SOFTWARE OVERVIEW
The AZPB70 software operates under Windows XP SP2+, Windows Vista and Windows 7 operating systems. The
software package includes a USB driver and a PC based interface program.
DRIVER INSTALLATION
Install the USB software driver before plugging the programmer board into the USB port. *Note – User must have
administrator rights to computer. Plug the USB flash drive into an unused USB port on the computer. Run the program
entitled “/Software/CP210x_VCP_Win_XP_S2K3_Vista_7.exe” from the USB flash drive and follow the on-screen
instructions. After driver installation, plug the programmer board into a USB port on the computer.
PROGRAM INSTALLATION
Copy the file “/Software/AZT70_71Programmer.exe” from the USB flash drive into the desired directory on the computer
hard disk.
AZT70/71 MODE SELECTION
Jumper JPR1 on the programming board selects the AZT70 or AZT71 mode. It is located next to the 6-pin ribbon cable
connector (Figure 8). The programmer board enters the AZT71 mode without the jumper. The programmer board enters
the AZT70 mode when the jumper is installed.
Figure 8 – Programmer board jumper location
www.azmicrotek.com
[phone]
5
Request a Sample
May 2012, Rev 1.2