AZPB70 Datasheet, PDF (2/15 Pages) Arizona Microtek, Inc – Programmer Board Kit for AZT70/71

Arizona Microtek, Inc.
AZPB70
Programmer Board for AZT70/71
HARDWARE OVERVIEW
The AZPB70 programmer board comes with all the hardware listed in Table 1. These hardware parts are necessary to
complete the setup shown in Figure 1 which is used to evaluate the AZT70 and AZT71 capacitive tuning ICs. For
production programming and measurement, the AZT70/71 should be soldered onto the oscillator PCB board where the 3
programming pins are accessible through the PCB substrate (Figure 2). Figure 3 and Figure 4 detail the top & bottom
views of the programmer board, respectively.
RESONATOR
OSCILLATOR
USB Cable
OUT
Programmer PCB
USB Cable
Programmer PCB
www.azmicrotek.com
[phone]
Request a Sample
6 pin ribbon cable
X₁
Measurement
device
Socket adapter board
Figure 1 – AZPB70 Hardware setup for evaluation
RESONATOR
OSCILLATOR
OUT
6 pin ribbon
cable
AZT70/71
DA _X1
CLK
PV
Programming pins accessed
through PCB substrate
Figure 2 – AZPB70 hardware setup for production
Measurement
device
2
May 2012, Rev 1.2