HCPL-2300-000E Datasheet, PDF (8/14 Pages) AVAGO TECHNOLOGIES LIMITED – 8 MBd Low Input Current Optocoupler

Package Characteristics
For -40°C ≤T_A ≤85°C, unless otherwise specified. All typicals at T_A = 25°C.
Parameter
Symbol Min. Typ. Max. Units Test Conditions
Fig. Notes
Input-Output Momentary
V_ISO
3750
V _rms RH ≤ 50%, t = 1 min,
3, 9
Withstand Voltage*
T_A = 25°C
Resistance, Input-Output
R_I-O
1012
Ω
V_I-O = 500 V
3
Capacitance, Input-Output
C_I-O
0.6
pF f = 1 MHz
3
*The Input-Output Momentary Withstand Voltage is a dielectric voltage rating that should not be interpreted as an input-output continuous voltage
rating. For the continuous voltage rating refer to the IEC/EN/DIN EN 60747-5-5 Insulation Characteristics Table (if applicable), your equipment level
safety specification, or Avago Application Note 1074, “Optocoupler Input-Output Endurance Voltage.”
Notes:
1. Bypassing the power supply line is required with a 0.1 µF ceramic
disc capacitor adjacent to each optocoupler as illustrated in Figure
19. The power supply bus for the optocoupler(s) should be separate
from the bus for any active loads, otherwise a larger value of bypass
capacitor (up to 0.5 µF) may be needed to suppress regenerative
feedback via the power supply.
2. Peaking circuits may produce transient input currents up to 100
mA, 500 ns maximum pulse width, provided average current does
not exceed 5 mA.
3. Device considered a two terminal device: pins 1, 2, 3, and 4 shorted
together, and pins 5, 6, 7, and 8 shorted together.
4. The t_PLH propagation delay is measured from the 50% point on the
trailing edge of the input pulse to the 1.5 V point on the trailing
edge of the output pulse.
5. The t_PHL propagation delay is measured from the 50% point on the
leading edge of the input pulse to the 1.5 V point on the leading
edge of the output pulse.
6. CM_H is the maximum tolerable rate of rise of the common mode
voltage to assure that the output will remain in a high logic state
(i.e., V_OUT > 2.0 V).
7. CM_L is the maximum tolerable rate of fall of the common mode
voltage to assure that the output will remain in a low logic state
(i.e., V_OUT < 0.8 V).
8. C_P is the peaking capacitance. Refer to test circuit in Figure 8.
9. In accordance with UL 1577, each optocoupler is momentary with-
stand proof tested by applying an insulation test voltage ≥4500
Vrms for 1 second (leakage detection current limit, I_I‑O ≤ 5 µA). This
test is performed before the 100% production test for partial dis-
charge (Method b) shown in the IEC/EN/DIN EN 60747-5-5 Insula-
tion Character­istics Table, if applicable.
Figure 2. Typical input diode forward charac-
teristics.
Figure 3. Typical output voltage vs. forward
input current vs. temperature.
Figure 4. Typical logic high output current vs.
temperature.
8