HCPL-2730-000E Datasheet, PDF (7/13 Pages) AVAGO TECHNOLOGIES LIMITED – Dual Channel Low Input Current, High Gain Optocouplers

Insulation Related Specifications (HCPL-2731/2730/0731/0730)


Parameter
Symbol
8-Pin DIP
(300 Mil)
Value
SO-8
Value Units
Minimum External Air
L(101)
7.1
4.9 mm
Gap (External Clearance)
Minimum External
L(102)
7.4
4.8 mm
Tracking (External
Creepage)
Minimum Internal Plastic
0.08
0.08 mm
Gap (Internal Clearance)


Tracking Resistance
CTI
200
200 Volts
(Comparative Tracking
Index)
Isolation Group
IIIa
IIIa
Conditions
Measured from input terminals to output
terminals, shortest distance through air.
Measured from input terminals to
output terminals, shortest distance
path along body.
Through insulation distance, conductor
to conductor, usually the direct distance
between the photoemitter and photode
tector inside the optocoupler cavity.
DIN IEC 112/ VDE 0303 Part 1
Material Group DIN VDE 0110
Option 300 – surface mount classification is Class A in accordance with CECC 00802.
IEC/EN/DIN EN 60747-5-2 Insulation Related Characteristics
Description
Installation Classification per DIN VDE 0110/1.89, Table 1
for rated mains voltage ≤600 V rms
for rated mains voltage ≤1000 V rms
Climatic Classification
Pollution Degree (DIN VDE 0110/1.89)
Maximum Working Insulation Voltage
Input to Output Test Voltage, Method b*
V_PR = 1.875 x V_IORM, 100% Production Test with t_P = 1 sec,
Partial Discharge < 5 pC
Input to Output Test Voltage, Method a*
V_PR = 1.5 x V_IORM, Type and Sample Test,
t_P = 60 sec, Partial Discharge < 5 pC
Highest Allowable Overvoltage*
(Transient Overvoltage, t_ini = 10 sec)
Safety Limiting Values
(Maximum values allowed in the event of a failure, also see
Figure 11, Thermal Derating curve.)
Case Temperature
Current (Input Current I_F, P_S = 0)
Output Power
Insulation Resistance at T_S, V_IO = 500 V
Symbol
VIORM
VPR
VPR
VIOTM
T_S
I_S,INPUT
P_S,OUTPUT
R_S
Characteristic
I-IV
I-III
55/100/21
2
1414
2652
Units
V _peak
V _peak
2121
V _peak
8000
V _peak
175
°C
400
mA
700
mW
> 10⁹
Ω
*Refer to the front of the optocoupler section of the current catalog, under Product Safety Regulations section, IEC/EN/DIN EN 60747-5-2, for a
detailed description.
Note: Isolation characteristics are guaranteed only within the safety maximum ratings which must be ensured by protective circuits in application.