AT91SAM7XC512_1 Datasheet, PDF (624/727 Pages) ATMEL Corporation – AT91 ARM Thumb-based Microcontrollers

39.5.1 Network Control Register
Register Name: EMAC_NCR
Access Type:
Read-write
31
30
29
28
27
26
25
24
–
–
–
–
–
–
–
–
23
22
21
20
19
18
17
16
–
–
–
–
–
–
–
–
15
14
13
12
11
10
9
8
–
–
–
–
–
THALT
TSTART
BP
7
6
5
4
3
WESTAT
INCSTAT
CLRSTAT
MPE
TE
2
1
0
RE
LLB
LB
• LB: LoopBack
Asserts the loopback signal to the PHY.
• LLB: Loopback local
Connects txd to rxd, tx_en to rx_dv, forces full duplex and drives rx_clk and tx_clk with pclk divided by 4.
rx_clk and tx_clk may glitch as the EMAC is switched into and out of internal loop back. It is important that receive
and transmit circuits have already been disabled when making the switch into and out of internal loop back.
• RE: Receive enable
When set, enables the EMAC to receive data. When reset, frame reception stops immediately and the receive FIFO is
cleared. The receive queue pointer register is unaffected.
• TE: Transmit enable
When set, enables the Ethernet transmitter to send data. When reset transmission, stops immediately, the transmit FIFO
and control registers are cleared and the transmit queue pointer register resets to point to the start of the transmit descrip-
tor list.
• MPE: Management port enable
Set to one to enable the management port. When zero, forces MDIO to high impedance state and MDC low.
• CLRSTAT: Clear statistics registers
This bit is write only. Writing a one clears the statistics registers.
• INCSTAT: Increment statistics registers
This bit is write only. Writing a one increments all the statistics registers by one for test purposes.
• WESTAT: Write enable for statistics registers
Setting this bit to one makes the statistics registers writable for functional test purposes.
• BP: Back Pressure
If set in half duplex mode, forces collisions on all received frames.
• TSTART: Start transmission
Writing one to this bit starts transmission.
• THALT: Transmit halt
624 AT91SAM7XC512/256/128 Preliminary
6209F–ATARM–17-Feb-09