E1106 Datasheet, PDF (5/14 Pages) ATMEL Corporation – E1106 User Manual

3
3.1
E1106 User Manual
QT1106 Demo Software
Introduction
QT1106 Demo software is used with the E1106 evaluation assembly. With QT1106 Demo software
you can send commands and see the effect that changing parameters has (see Section 3.2
onwards).
Numerical Indicator
Wheel/Slider Indicator
Shows the numerical equivalent Shows the last reported
of the last reported touch position
touch position
(see Page 6)
(see Page 6)
Key 6 is shown
being touched.
Keys Indicators:
Shows which key is
being touched and
also allows each
key to be calibrated
individually
(see Page 6)
Cal All Keys:
Calibrates all the keys
simultaneously
(see Page 6)
Cal Wheel/Slider:
Calibrates the
wheel/slider
(see Page 6)
Setup:
Accesses the Setup
parameters
(see Page 6)
Exit:
Closes the QT1106
Demo software
(see Page 6)
Figure 3: QT1106 Main Window
Connection:
Connection indicator (green) is constant when
the E1106 is connected to the computer,
flickering when it is not (see Page 6)
Wheel/Slider:
Slider Mode
Detection Thresh
Resolution
Calibration
Signal Error
Detection
(see Page 6)
Keys:
Calibration
Signal Error
QMagic Prox
(see Page 7)
AKS Modes:
(see Page 7)
General:
Max On Duration Detect Integrator
(see Page 7)
Operating
Modes:
(see Page 7)
Low Power/Sync
/Sleep Mode:
Enables parameters for
these modes
(see Page 8)
Restore Defaults:
Restores the default
parameters
(see Page 8)
Enable/disable sound
when wheel/slider or keys
are touched
(see Page 8)
Figure 4: QT1106 Setup Dialog Box
Enable/disable to show the
AKS groups in the main
window
(see Page 8)
5 of 14