E1106 Datasheet, PDF (4/14 Pages) ATMEL Corporation – E1106 User Manual

E1106 User Manual
2 Setting Up the E1106
To prepare the E1106 for use, proceed as follows:
1. Connect the E1106 control board to the QWheel or QSlide evaluation assembly, ensuring
correct orientation of the connector (see Figure 2).
2. Using the USB cable provided, connect the E1106 control board to the computer (see
Figure 2). The LED on the E1106 is lit constantly to indicate that there is power to the board.
3. Install the QT1106 Demo software; either method is acceptable:
a. Put the supplied CD in the CD drive of the computer. Copy the contents of the CD to the
computer. Double-click the QT1106 Demo software to open it.
OR
b. Go to www.qprox.com, point to the Support tab and click Download Archive. Click
Software and then the QT1106 Demo link. A dialog box appears asking if you want to run
or save the file that you are about to download. Click Run. This automatically downloads
the software.
If a dialog box appears saying “The publisher could not be verified. Are you sure you want
to run this software?” click Run.
4. QT1106 Demo software is displayed on the computer monitor (see Figure 3, page 5).
Note: the E1106 QWheel and QSlide assemblies are supplied with a grounded transparent
backplate that allows the assemblies to be operated while being handheld, without requiring
recalibration. The backplate can be removed if required.
Control board
should be
component
side up.
Connecting the E1106 Control Board to the E1106 QWheel or QSlide
USB cable to computer
LED
QWheel
Assembly
Connections between the E1106 Control Board and computer
Figure 2: E1106 Connections
4 of 14