AT24C16C-SSHM-T Datasheet, PDF (18/24 Pages) ATMEL Corporation – Two-wire Serial Electrically Erasable and Programmable Read-only Memory

8A2 – TSSOP
3 21
Pin 1 indicator
this corner
E1
E
L1
N
Top View
L
End View
COMMON DIMENSIONS
(Unit of Measure = mm)
A
b
e
A2
D
Side View
SYMBOL
D
E
E1
A
A2
b
e
L
L1
MIN
2.90
4.30
–
0.80
0.19
0.45
NOM
3.00
6.40 BSC
4.40
–
1.00
–
0.65 BSC
0.60
1.00 REF
MAX
3.10
4.50
1.20
1.05
0.30
0.75
NOTE
2, 5
3, 5
4
Notes:
1. This drawing is for general information only. Refer to JEDEC Drawing MO-153, Variation AA, for proper dimensions,
tolerances, datums, etc.
2. Dimension D does not include mold Flash, protrusions or gate burrs. Mold Flash, protrusions and gate burrs shall
not exceed 0.15 mm (0.006 in) per side.
3. Dimension E1 does not include inter-lead Flash or protrusions. Inter-lead Flash and protrusions shall not exceed
0.25 mm (0.010 in) per side.
4. Dimension b does not include Dambar protrusion. Allowable Dambar protrusion shall be 0.08 mm total in excess
of the b dimension at maximum material condition. Dambar cannot be located on the lower radius of the foot.
Minimum space between protrusion and adjacent lead is 0.07 mm.
5. Dimension D and E1 to be determined at Datum Plane H.
5/19/10
TITLE
Package Drawing Contact: 8A2, 8-lead 4.4mm Body, Plastic Thin
[e-mail] _{Shrink Small Outline Package (TSSOP)}
GPC DRAWING NO. REV.
TNR
8A2
E
18 Atmel AT24C16C
8719A–SEEPR–9/10