7075 Datasheet, PDF (7/8 Pages) ASM GmbH – WAVEFORM GENERATOR

6
Specifications (23˚C ± 5˚C/73˚F ± 9˚F, after 30 minutes warmup)
-1. General Specifications
Number of
Channels:
Output Functions:
Display:
Language:
External Memory
System:
Interfaces:
Electrostatic
Endurance:
4 (7075), 2 (7075-1)
Function Generator, Arbitrary Waveform Generator
(settable for each channel)
5.7" LCD (with Touch Panel)
Japanese or English selectable
3.5" Floppy Drive
Storage Capacity: 1.44 MB, 1.2 MB and 720 kB compatible
(1.2 MB format is non-standard)
Data format: MS-DOS^™ format
GP-IB (IEEE 488.1 compliant. Refer to IEEE 488.2)
RS-232C (Dsub 9-pin connector, 19200, 9600 and 4800 bps
speed, for waveform data transfer only -- not for control)
Power (cumulative)- single pulse to chassis/
AC 1.5 kVrms for 1 min. 25 mA
Environmental
Conditions:
(non-condensating)
Power:
Maximum Rated
Dissipation:
Dimensions and
mass :
Accessory:
Conforming
Standards:
Operating temperature: 10 to 40˚C (50 to 104˚F) 85% RH or less
Storage temperature: -10 to 50˚C (14 to 122˚F) 85% RH or less
Operating location: Indoors, at less than 2,000m (6,562-ft.) altitude
Auto selects 100, 120, 200 or 230 VAC (±10%), 50/60 Hz
120 VA
345W × 130H × 286D mm, 7.8 kg (7075) / 7.5 kg (-01)
13.6" W × 5.1" H × 11.3" D, 275 oz. (7075) / 265 oz. (-01)
7990 WAVEFORM CREATION SOFTWARE (3 floppy disks)
EMC
EN55011:1991+A1:1997+A2:1996
EN50082-1:1992
Safety
EN61010-1:1993+A2:1995
Pollution level 2, Overvoltage category II
(anticipated transient overvoltage 2,5 kV)
-2. Analog Output (common to Function Generator and Custom Waveform Outputs)
Max. Output
Voltage:
Amplitude Setting
Ranges:
(setting is peak level)
DC Offset:
(setting range)
Minimum Load
Impedance:
±10 V o.c. (o.c. = open-circuit)
10 V Range: 0 to 10 V o.c. (1 mV resolution)
1 V Range: 0 to 1 V o.c. (0.1 mV resolution)
0.1 V Range: 0 to 0.1 V o.c. (0.01 mV resolution)
10 V Range: -10 V to 10 V o.c. (1 mV resolution)
1 V Range: -1 V to 1 V o.c. (0.1 mV resolution)
0.1 V Range: -0.1 V to 0.1 V o.c. (0.01 mV resolution)
40 Ω
Output Impedance:
Rise and Fall
Times:
Overshoot:
Interchannel
Skew:
Output Range
Accuracy:
50 Ω ±2% (DC)
< 45 ns (from 10 to 90% of peak amplitude square wave,
with LPF bypassed, RL=50 Ω
Selected amplitude (within ±5% of p-p value of square wave,
with LPF bypassed, RL=50 Ω
Within 25 ns (determined at simultaneous waveform selection)
1 V Range: add 0.2% of range to 10 V range accuracy
0.1 V Range: add 0.4% of range to 10 V range accuracy
Note: refer to the following Function Generator and
Arbitrary Waveform Generator sections for 10 V range accuracy
-3. Function Generator Mode (Accuracy is determined at 10V range)
Waveform Types:
Frequency Range:
Frequency
Accuracy:
sine, square (fixed 50% duty), triangle, ramp-up,
ramp-down, pulse, noise, DC
Sine wave: 0 to 10 MHz (10 mHz resolution)
Square wave: 0 to 10 MHz (10 mHz resolution)
Triangle wave: 0 to 200 kHz (10 mHz resolution)
Ramp waves: 0 to 200 kHz (10 mHz resolution)
Pulse wave: 0 to 200 kHz (10 mHz resolution)
within ±50 ppm ±50 µHz of setting
DC Offset Accuracy:
DC Offset Stability:
Amplitude Accuracy:
Amplitude Stability:
Phase Adjustment:
Jitter:
Square Wave Duty
Cycle:
Pulse Wave Duty
Cycle:
within ±0.5% ±25 mV of setting
within ±DC Offset Accuracy × 0.1 per ˚C
within 2% ±20 mVrms of setting (for 1 kHz sine wave)
within (Amplitude Accuracy × 0.1) per ˚C
-360.00 to 360.00˚ (0.01˚ resolution)
within 100 ns p-p (triangle, ramp and pulse waves)
fixed (40 to 60%)
adjustable from 1 to 99% (0.1% resolution)
(Pulse width must be 100 ns or greater)
-4. Arbitrary Waveform Generation Mode (Accuracy is determined at 10V range)
Voltage Axis
Resolution:
Waveform Memory
Capacity:
Filtering:
Waveform Input
Methods:
DC Output
Accuracy:
DC Output
Stability:
16 bits (64,000 counts)
128,000 Words/channel (channel independent)
2-stage LPF, 50 Hz to 1 MHz (14 steps in 1-2-5 progression)
Floppy Disk, GP-IB or RS-232C download
(direct download from MEMORY HiCORDER)
within ±2% ±25 mV of setting
within ±DC Output Accuracy × 0.1 per ˚C
Amplitude
Accuracy:
Delay:
Custom Waveform
Clock:
within 2% ±20 mVrms of setting
(for 10,000 Words, 10 MHz clock sine wave)
Settable within ±128,000 in 1-clock units
Max. 4 channels (same as waveform output)
Frequency range: 10 mHz to 10 MHz (10 mHz resolution)
Frequency accuracy: within ±50 ppm ±50 µHz of setting
Jitter: the larger of the effect within 800 ps, or within 0.05%
of period setting