7075 Datasheet, PDF (3/8 Pages) ASM GmbH – WAVEFORM GENERATOR

2
Easy Touch Panel Operation
Operating Screen Examples
Output Settings Screen
1
The settings for output waveforms on
every channel are simultaneously
displayed.
Sweep Setup Screen
A waveform is selected and related
sweep selections such as frequency and
amplitude can then be set, as well as
basic setting of non-sweep functions.
Sweep Table Editing Screen
Sweep conditions such as amplitude and
frequency for each item can be set, for
sequences of up to 128 steps.
Waveform Selection Screen
The desired standard function generator
waveform can be selected from sine
wave, square wave, etc., or a list of
arbitrary waveforms can be selected.
Waveform Input Screen
2
Up to 8 waveforms can be entered and
stored in the unit.
V
RUN
5
2
0
-2
-5
3s
2s
1s
2s 500ms
Time
Arbitrary Waveform List Screen
All waveforms entered in the 7075 are
displayed.
Arbitrary Waveform View Screen
Displays details of an entered waveform.
The waveform image, amplitude, output
time and other information can be
confirmed.
Floppy Disk/Interface Setup
3 Screen
Sets up the floppy disk, GP-IB and
RS-232C interfaces.
Floppy Disk Save/Load Setup Screen
Waveforms can be saved and floppy disk
conditions can be set, or files loaded into
the unit.
System Screen
4
Configure basic operating
settings of the unit.