DS1100SDC Datasheet, PDF (6/8 Pages) Artesyn Technologies – Distributed Power System

DS1100SDC Data Sheet
Control and Status Signals
Output Signals
PS_PRESENT_L
Signal used to indicate to the system that a power supply is inserted in the power bay. This pin is shorted to the standby return in the power supply.
Recommended pull-up resistor to 12 VSB is 8.2 k with a 3.0 k pull-down to ground. A 100 pF decoupling capacitor is also recommended.
PS_INTERRUPT_L
Active low signal used by the power supply to indicate to the system that a change in power supply status has occurred. This event can be
triggered by faults such as OVP, OCP, OTP, and fan fault. This signal can be cleared by a CLEAR_FAULT command. Recommended pull-up resis-
tor to 12 VSB is 8.2 k with a 3.0 k pull-down to ground. A 100 pF decoupling capacitor is also recommended.
V_IL
V_IH
I_SOURCE
I_SINK
BUS Signals
Input logic level LOW
Input logic level HIGH
Current that may be sourced by this pin
Current that may be sunk by this pin at low state
MIN
2.0 V
MAX
0.8 V
5.0 V
4 mA
4 mA
ISHARE
Bus signal used by the power supply for active current sharing. All power supplies configured in the system for n+n sharing will refer to this bus
voltage inorder to load share.
Voltage Range
The range of this signal for active sharing will be up to 8.0 V, which corresponds to the maximum output current.
I_SHARE Voltage
Input logic level LOW
Voltage at 50% load, stand-alone unit
MIN
MAX
7.75
8.25
3.85
4.15
I_SOURCE
SCL, SDA
Voltage at 0% load, stand-alone unit
Current that may be sourced by this pin
0
0.3
160 mA
Clock and data signals defined as per I²C requirements. It is recommended that these pins be pulled-up to a 2.2 kohm resistor to 3.3 V and a
100 pF decoupling capacitor at the system side.
VL
Input logic level LOW
0.8 V
VH
Input logic level HIGH
2.0 V
5.0 V
Note: All signal noise levels are below 400 mVpk-pk from 0 - 100 MHz.
I²C Addressing Table: Not applicable. This power supply has a fixed I²C address. In order to support multiple addresses, the system will have to
utilize a switcher or an I²C expander.
Ordering Information
Model Number
DS1100SDC-3
DS1100SDC-3-001
1 _{Derating may apply}
Nominal Main Output
12 V
12 V
Standby Output
12 V @ 3A
12 V @ 3A
Airflow Direction
Std (forward)
Reverse¹