AAT1161 Datasheet, PDF (8/18 Pages) Advanced Analogic Technologies – 13.2V Input, 3A Step-Down Converter

SwitchReg^TM
Functional Block Diagram
FB
*
PRODUCT DATASHEET
AAT1161
13.2V Input, 3A Step-Down Converter
LDO
Internal
Power
Current
Sense Amp
AIN
IN
LDO
Voltage
Reference
Err
Amp
EN
Input
Comp
DH
Control
Logic
COMP
* For fixed output voltage versions, FB is connected to the error amplifier through the resistive voltage divider shown.
LX
PGND
DGND
AGND
Functional Description
The AAT1161 is a current-mode step-down DC/DC con-
verter that operates over a wide 4V to 13.2V input voltage
range and is capable of supplying up to 3A to the load
with the output voltage regulated as low as 0.6V. The
P-channel power switch is internal, reducing the number
of external components required. An external Schottky
diode is used for the low side rectifier. The output voltage
is adjusted by an external resistor divider; fixed output
voltage versions are available upon request. The regula-
tion system is externally compensated, allowing the cir-
cuit to be optimized for each application. The AAT1161
includes cycle-by-cycle current limiting, frequency fold-
back for improved short-circuit performance, and thermal
overload protection to prevent damage in the event of an
external fault condition.
Control Loop
The AAT1161 regulates the output voltage using con-
stant frequency current mode control. The AAT1161
monitors current through the high-side P-channel
MOSFET and uses that signal to regulate the output volt-
age. This provides improved transient response and
eases compensation. Internal slope compensation is
included to ensure the current “inside loop” stability.
High efficiency is maintained under light load conditions
by automatically switching to variable frequency Light
Load control. In this condition, transition losses are
reduced by operating at a lower frequency at light loads.
The AAT1161 uses an external Schottky rectifier diode to
minimize cost.
8
www.analogictech.com
1161.2008.03.1.0