AAT2315_07 Datasheet, PDF (2/22 Pages) Advanced Analogic Technologies – Dual 600mA Step-Down Converter with Synchronization

AAT2513
Dual 600mA Step-Down
Converter with Synchronization
Pin Descriptions
Pin #
1
2
4, 3
5, 16
6, 15
7, 14
8, 13
10, 9
11
12
EP
Symbol
PS
AGND
FB1, FB2
VIN1, VIN2
N/C
LX1, LX2
PGND1, PGND2
EN1, EN2
VCC
MODE/SYNC
Function
Phase shift pin. Logic high enables the PS feature which forces the two converters
to operate 180° out of phase when both are in forced PWM mode.
Analog ground. Return the feedback resistive divider to this ground. See section on
PCB layout guidelines and evaluation board layout diagram.
Feedback input pins. An external resistive divider ties to each and programs the
respective output voltage to the desired value.
Input supply voltage pins. Must be closely decoupled to the respective PGND.
Not connected
Output switching nodes that connect to the respective output inductor.
Main power ground return. Connect to the input and output capacitor return. See
section on PCB layout guidelines and evaluation board layout diagram.
Converter enable input pins. A logic high enables the converter channel. A logic low
forces the channel into shutdown mode, reducing the channel supply current to less
than 1µA. This pin should not be left floating. When not actively controlled, this pin
can be tied directly to VIN and/or VCC.
Control circuit power supply. Connect to the higher voltage of VIN1 or VIN2.
Logic low enables automatic light load mode for optimized efficiency throughout the
entire load range. Logic high forces low noise PWM operation under all operating
conditions. Connect to an external clock for synchronization (PWM only).
Exposed paddle (bottom). Use properly sized vias for thermal coupling to the
ground plane. See section on PCB layout guidelines.
Pin Configuration
QFN33-16
(Top View)
PS ¹
AGND ²
FB2 ³
FB1 ⁴
12 _MODE/SYNC
11 VCC
10 _EN1
9 _EN2
2
2513.2007.04.1.1