AAT1162_08 Datasheet, PDF (2/18 Pages) Advanced Analogic Technologies – 12V, 1.5A Step-Down DC/DC Converter

SwitchReg^TM
PRODUCT DATASHEET
AAT1162
12V, 1.5A Step-Down DC/DC Converter
Pin Descriptions
Pin #
1, 2, EP2
3, 12
4, 5
6, 13,
14, EP1
7
8
9
10
11
15
16
Symbol
LX
N/C
IN
DGND
AIN
LDO
FB
COMP
AGND
EN
PGND
Function
Power switching node. LX is the drain of the internal P-channel switch and N-channel synchronous recti-
fier. Connect the output inductor to the two LX pins and to EP2. A large exposed copper pad under the
package should be used for EP2.
Not connected.
Power source input. Connect IN to the input power source. Bypass IN to DGND with a 22μF or greater
capacitor. Connect both IN pins together as close to the IC as possible. An additional 100nF ceramic
capacitor should also be connected between the two IN pins and DGND, pin 6
Exposed Pad 1 Digital Ground, DGND. The exposed thermal pad (EP1) should be connected to board
ground plane and pins 6, 13, and 14. The ground plane should include a large exposed copper pad under
the package for thermal dissipation (see package outline).
Internal analog bias input. AIN supplies internal power to the AAT1162. Connect AIN to the input source
voltage and bypass to AGND with a 0.1μF or greater capacitor. For additional noise rejection, connect to
the input power source through a 10Ω or lower value resistor.
Internal LDO bypass node. The output voltage of the internal LDO is bypassed at LDO. The internal
circuitry of the AAT1162 is powered from LDO. Do not draw external power from LDO. Bypass LDO to
AGND with a 1μF or greater capacitor.
Output voltage feedback input. FB senses the output voltage for regulation control. For fixed output
versions, connect FB to the output voltage. For adjustable versions, drive FB from the output voltage
through a resistive voltage divider. The FB regulation threshold is 0.6V.
Control compensation node. Connect a series RC network from COMP to AGND, R = 51k and C = 150pF.
Analog signal ground. Connect AGND to PGND at a single point as close to the IC as possible.
Active high enable input. Drive EN high to turn on the AAT1162; drive it low to turn it off. For automatic
startup, connect EN to IN through a 4.7kΩ resistor. EN must be biased high, biased low, or driven to a
logic level by an external source. Do not let the EN pin float when the device is powered.
Power ground. Connect AGND to PGND at a single point as close to the IC as possible.
Pin Configuration
TDFN34-16
(Top View)
LX ¹
LX ²
N/C ³
IN ⁴
IN ⁵
DGND ⁶
AIN ⁷
LDO ⁸
EP2
EP1
16 _PGND
15 _EN
14 _DGND
13 _DGND
12 _N/C
11 _AGND
10 _COMP
9 _FB
2
www.analogictech.com
1162.2008.01.1.3