ALT6705 Datasheet, PDF (7/12 Pages) ANADIGICS, Inc – HELP4 UMTS800 (Bands 5, 6, 18, 19, & 26) LTE, WCDMA, CDMA Multimode PAM

ALT6705
APPLICATION INFORMATION
To ensure proper performance, refer to all related
Application Notes on the ANADIGICS web site:
http://www.anadigics.com
to the VMODE voltages. The Bias Control table below
lists the recommended modes of operation for various
applications.
Shutdown Mode
The power amplifier may be placed in a shutdown mode
by applying logic low levels (see Operating Ranges
table) to the VEN, VMODE1 and VMODE2 voltages.
Bias Modes
The power amplifier may be placed in either Low,
Medium or High Bias modes by applying the
appropriate logic level (see Operating Ranges table)
Three operating modes are recommended to optimize
current consumption. High Bias/High Power operating
mode is for POUT levels > 17 dBm. At ~17dBm - 8
dBm, the PA should be “Mode Switched” to Medium
Power Mode. For POUT levels < ~7 dBm, the PA can be
switched to Low Power Mode for even lower quiescent
current consumption.
APPLICATION
POUT
LEVELS
Low power
(Low Bias Mode)
 +7 dBm
Med power
> 7 dBm
(Medium Bias Mode)  +17 dBm
High power
(High Bias Mode)
> +17 dBm
Table 7: Bias Control
BIAS
MODE
VEN
VMODE1
VMODE2
Low +1.8 V +1.8 V +1.8 V
Low +1.8 V +1.8 V 0 V
High +1.8 V 0 V
0V
VCC
3.1 - 4.35 V
3.1 - 4.35 V
3.1 - 4.35 V
Shutdown
-
Shutdown 0 V
0V
0V
3.1 - 4.35 V
VBATT
> 3.1 V
> 3.1 V
> 3.1 V
> 3.1 V
VBATT
C5
C1 C9
2.2 µF _{0.01 µF 100 pF}
RFIN
VMODE2
VMODE1
VEN
GND at slug
1 _VBATT
2 _RFIN
3 _VMODE2
4 _VMODE1
5 _VEN
VCC ¹⁰
RFOUT ⁹
CPLIN ⁸
GND ⁷
CPLOUT ⁶
VCC
C3
C2
C4
330 pF 0.01 µF ^{2.2 µF ceramic}
CPLIN
RFOUT
CPLOUT
Figure 3: Evaluation Board Schematic
7
Data Sheet - Rev 2.5
03/2012