English
Language : 

TCS3771 Datasheet, PDF (6/33 Pages) ams AG – COLOR LIGHT-TO-DIGITAL CONVERTER with PROXIMITY SENSING
TCS3771
COLOR LIGHT-TO-DIGITAL CONVERTER
with PROXIMITY SENSING
TAOS110A − MARCH 2011
Proximity Characteristics, VDD = 3 V, TA = 255C, Gain = 16, PEN = 1 (unless otherwise noted)
PARAMETER
TEST CONDITIONS
CONDITION
MIN TYP MAX UNIT
IDD Supply current
ADC conversion time step size
LDR pulse on
PTIME = 0xFF
3
mA
2.27 2.4 2.56 ms
ADC number of integration steps
1
256 steps
ADC counts per step
0
1023 counts
IR LED pulse count
0
255 pulses
LED pulse period
Two or more pulses
14
μs
LED pulse width — LED on time
6.3
μs
lid PDRIVE = 0
80 106
132
LED drive current
ISINK sink current @ 600 mV,
LDR pin
PDRIVE = 1
PDRIVE = 2
50
mA
25
a PDRIVE = 3
12.5
Dark count value
ill v Red channel
Ee = 0, PTIME = 0xFB, PPULSE = 2
λP = 850 nm, Ee = 45.3 μW/cm2, PTIME = 0xFB,
PPULSE = 2 (See note 1)
1000
900 counts
3000 counts
Clear channel
λP = 850 nm, Ee = 45.3 μW/cm2, PTIME = 0xFB,
PPULSE = 2 (See note 1)
1000
3000 counts
t Operating distance (See note 2)
30
inches
NOTES: 1. The specified light intensity is 100% modulated by the pulse output of the device so that during the pulse output low time, the light
G s intensity is at the specified level, and 0 otherwise.
2. Proximity Operating Distance is dependent upon emitter properties and the reflective properties of the proximity surface. The
A t nominal value shown uses an IR emitter with a peak wavelength of 850nm and a 20° half angle. The proximity surface used is a
90% reflective (white surface) 16 × 20-inch Kodak Gray Card. 60 mw/SR, 100 mA, 64 pulses, open view (no glass). Note: Greater
distances are achievable with appropriate system considerations.
s en Wait Characteristics, VDD = 3 V, TA = 255C, Gain = 16, WEN = 1 (unless otherwise noted)
m t PARAMETER
TEST CONDITIONS
CHANNEL
MIN TYP MAX
a n Wait step size
WTIME = 0xFF
2.27 2.4 2.56
Technical co Wait number of steps
1
256
UNIT
ms
steps
The LUMENOLOGY r Company
r
r
www.taosinc.com
Copyright E 2011, TAOS Inc.
5