AMIS-39101 Datasheet, PDF (5/15 Pages) AMI SEMICONDUCTOR – Octal High-Side Driver with Protection

AMIS-39101: Octal High-Side Driver with Protection
Data Sheet
8.0 Electrical and Environmental Ratings
8.1 Absolute Maximum Ratings
Stress levels above those listed in this paragraph may cause immediate and permanent device failure. It is not recommended that
more than one of these conditions be applied simultaneously.
Table 3: Absolute Maximum Ratings
Symbol
Description
Min.
VDDN
Power supply voltage
GND - 0.3
VS
VS power supply on pins VS1 to VS4, load dump,
Pulse 5b 400ms
GND - 0.3
Iout_ON
Maximum output current OUTx pins⁽¹⁾
The HS driver is switched on
-3000
Iout_OFF
Maximum output current OUTx pins⁽¹⁾
The HS driver is switched off
-350
I_OUT_VS Maximum output current VS1, 2, 3, 4 pins
-700
Vcapa1
DC voltage on pin CAPA1
0
Vdig_in
V_ESD
V_ESD
Tj
Voltage on digital inputs CLK, PDB, WR, DIN
Pins that connect the application (pins VS1..4 and Out1..8)⁽²⁾
All other pins⁽²⁾
ESD according charged device model⁽³⁾
Junction temperature (T<100 hours)
-0.3
-4
-2
-750
-40
Tmr
Ambient temperature under bias
-40
Notes:
(1)
(2)
(3)
The power dissipation of the chip must be limited not to exceed the maximum junction temperature Tj.
According to HBM standard MIL-STD-883 method 3015.7.
According to norm EOS/ESD-STM5.3.1-1999 robotic mode.
Max.
Unit
6
V
35
V
350
mA
350
mA
3750
mA
VS+16.5
V
VDDN+0.3
V
+4
kV
+2
kV
+750
V
175
°C
85
°C
8.2 Thermal Characteristics
Table 4: Thermal Characteristics of the Package
Symbol
Description
R_th(vj-a)
Thermal resistance from junction to ambient in power-SO28 package
Conditions
In free air
Value
145
Unit
K/W
Table 5: Thermal Characteristics of the AMIS-39101 on a PCB
PCB Design
Conductivity Top and Bottom Layer
Two layer (35um) Copper planes according to Figure 4 + 25% copper for the remaining areas
Two layer (35um) Copper planes according to Figure 4 + 0% copper for the remaining areas
Four layer JEDEC: 25% copper coverage
EIA/JESD51-7
One layer JEDEC: 25% copper coverage
EIA/JESD51-3
Note:
(1) These values are for general information purposes only, and will change based on each specific PCB design.
Rthja ⁽¹⁾
24
53
25
46
Unit
K/W
K/W
K/W
K/W
AMI Semiconductor – November 06 - M-20638-001
5
www.amis.com