AMIS-710205 Datasheet, PDF (4/9 Pages) AMI SEMICONDUCTOR – 200dpi CIS Modules

AMIS-710205-A4/AMIS-710206-A4: 200dpi CIS Modules
Data Sheet
7.0 Environmental Specifications
Table 5: Operating and Storage Environment
Parameter
Operating temperature⁽¹⁾
Operating humidity⁽¹⁾
Storage temperature⁽¹⁾
Storage humidity⁽¹⁾
Symbols
Top
Hop
Tstg
Hstg
Note:
(1) These are standard specifications for the CIS modules.
Range
0 to 50
10 to 90
-20 to +75
10 to 90
Units
°_C
%
°_C
%
8.0 Electro-Optical Characteristics (25^°C)
Table 6 is the electro-optical characteristics common to all three modules. Table 7 shows the characteristics for each of the two LED
light sources.
Table 6: Common Electro-Optical Characteristics
Parameter
Total number of photo detectors
Section 1, 2 & 3 number of photo
detectors
Section 4 number of detectors
Pixel-to-pixel spacing
Symbol
Value
1728
448
384
125
Units
Elements
Elements
Elements
µm
Notes
Table 7: AMIS-710205/206-A4 Electro-Optical Characteristics
AMIS-710205-A4
AMIS-710206-A4
Parameter
Line scanning rate
Symbol
Tint⁽¹⁾
IR LED (880nm)
Red LED (630nm)
Value
90
Units
µsec
Clock frequency⁽²⁾
Bright output voltage⁽³⁾
Bright output non-uniformity⁽⁴⁾
Dark non-uniformity⁽⁵⁾
Dark output voltage⁽⁶⁾
Modulation transfer function⁽⁷⁾
Fclk
Video output
Up
Ud
Dark level (DL)
MTF
5.0
1.0
<+/-30
<40
<200
>40
MHz
Volt
%
mV
mV
%
Notes:
(1) Tint is the line scanning rate or integration time. Tint is determined by the interval between two start pulses (SP).
(2) Fclk: main clock frequency also equals the video sampling frequency.
(3) Video output level is controlled with a voltage adjustment as well as the Integration time and the LED light power.
(4) Up = {[Vp(max) –Vp(min)]/Vp(max)}x100%
Where Vp(max) = maximum peak pixel and Vp(min) = minimum pixel.
(5) Ud = Vdmax – Vdmin
Vdmin is the minimum output voltage with the LED off.
Vdmax is maximum output voltage with the LED on.
(6) See Section.9.0.
Note
@ 5.0MHz clock
frequency
AMI Semiconductor – Aug. 06, M-20608-001
4
www.amis.com