EP4CGX75CF23I7N Datasheet, PDF (7/42 Pages) Altera Corporation – Cyclone IV Device Datasheet

Chapter 1: Cyclone IV Device Datasheet
1–7
Operating Conditions
DC Characteristics
This section lists the I/O leakage current, pin capacitance, on-chip termination (OCT)
tolerance, and bus hold specifications for Cyclone IV devices.
Supply Current
The device supply current requirement is the minimum current drawn from the
power supply pins that can be used as a reference for power size planning. Use the
Excel-based early power estimator (EPE) to get the supply current estimates for your
design because these currents vary greatly with the resources used. Table 1–6 lists the
I/O pin leakage current for Cyclone IV devices.
Table 1–6. I/O Pin Leakage Current for Cyclone IV Devices ^{(1), (2)}
Symbol
Parameter
Conditions
Device
Min
Typ Max Unit
I_I
Input pin leakage current V_I = 0 V to V_CCIOMAX
—
I_OZ
Tristated I/O pin leakage
current
V_O = 0 V to V_CCIOMAX
—
–10
—
10 A
–10
—
10 A
Notes to Table 1–6:
(1) This value is specified for normal device operation. The value varies during device power-up. This applies for all V_CCIO settings (3.3, 3.0, 2.5,
1.8, 1.5, and 1.2 V).
(2) The 10 A I/O leakage current limit is applicable when the internal clamping diode is off. A higher current can be observed when the diode is on.
Bus Hold
The bus hold retains the last valid logic state after the source driving it either enters
the high impedance state or is removed. Each I/O pin has an option to enable bus
hold in user mode. Bus hold is always disabled in configuration mode.
Table 1–7 lists bus hold specifications for Cyclone IV devices.
Table 1–7. Bus Hold Parameter for Cyclone IV Devices (Part 1 of 2) ⁽¹⁾
V_CCIO (V)
Parameter Condition
1.2
1.5
1.8
2.5
3.0
3.3
Unit
Bus hold
low,
sustaining
current
Bus hold
high,
sustaining
current
Bus hold
low,
overdrive
current
Bus hold
high,
overdrive
current
V_IN > V_IL
(maximum)
Min Max Min Max Min Max Min Max Min Max Min Max
8 — 12 — 30 — 50 — 70 — 70 — A
V_IN < V_IL
(minimum)
–8 — –12 — –30 — –50 — –70 — –70 — A
0 V < V_IN < V_CCIO — 125 — 175 — 200 — 300 — 500 — 500 A
0 V < V_IN < V_CCIO — –125 — –175 — –200 — –300 — –500 — –500 A
December 2013 Altera Corporation
Cyclone IV Device Handbook,
Volume 3