AKD4589 Datasheet, PDF (9/51 Pages) Asahi Kasei Microsystems – AK4589 Evaluation Board Rev.2

ASAHI KASEI
[AKD4589-B]
AKD4589 (DIR/DIT) part Control Program operation manual
„ Set-up of evaluation board and control software
(Note)
Control software does not support to I²C control, and does not work on Windows NT
Windows 2000/XP needs an installation of driver.
Windows 95/98/ME does not need an installation of driver.
Please refer to “Installation Manual of Control Software Driver by AKM device control software”
about the method of installation of driver.
1. Set up the AKD4589-B according to above mentioned setting.
2. Connect printer port(parallel port) of PC and PORT1(up-I/F) of AKD4589-B by 10-wire flat cable packed with
AKD4589. Then take care of the direction of 10pin connector and 10 pin header.
3. Insert the CD-ROM labeled “AK4589-B Control Program ver 2.0” into the CD-ROM drive.
4. Access the CD-ROM drive and double-click the icon of “akd4589-b_dir_dit_2.exe”
and set up the control program.
5. Then evaluate AK4589 (DIR/DIT) part according to the follows.
„ Operation flow
Keep the following flow.
1. Set up the control program according to explanation above.
2. Click Write default button.
3. Then set up the dialog and input data and evaluate AK4589 (DIR/DIT) part.
„ Explanation of each buttons
1. [Write default]: Write default data into all registers.
Default data is indicated on the register map of all registers.
Red letter indicates “H” or “1” and blue letter indicates “L” or “0”.
Blank is the part that is not defined in the datasheet.
2. [All Read]: Read data of all registers.
Read data is indicated on the register map of all register.
Red letter indicates “H” or “1” and blue letter indicates “L” or “0”.
Blank is the part that is not defined in the datasheet.
3. [Function1]: Set up dialog to write data by keyboard operation.
4. [Write]:
It exists on each register corresponding to all registers.
Set up dialog to write data to each register by mouse operation.
Set ON/OFF by clicking each bits.
Click “OK” button if you write input data to register.
Click “Cancel” button if you don’t write input data to register .
5. [Read]:
It exists on each register corresponding to some registers.
Read data from one of each register.
Read data is indicated on the register map of the register.
Red letter indicates “H” or “1” and blue letter indicates “L” or “0”.
Blank is the part that is not defined in the datasheet.
<KM076201>
-9-
2005/07